700rb-ii & 1001rb-ii owner’s manual.
2 700rb-ii & 1001rb-ii congratulations always listening we’ll be listening, robert gallien introduction your purchase of a new gallien-krueger amplifier is surely the result of much careful consideration on your part. For our part, we at gallien-krueger are pleased that you chose us, and are determi...
3 700rb-ii & 1001rb-ii table of contents table of contents c a u t i o n risk of electric shock do not open ! ! C a u t i o n : warning: to reduce the risk of electric shock, do not remove top cover. No user-serviceable parts inside. Refer servicing to qualified service personnel. To reduce the risk...
4 700rb-ii & 1001rb-ii safety information safety information please read all enclosed safety precautions before connecting or operating this product. Your amplifier has been factory configured for use with the specific line voltage for your location only. For example, units set to operate within cou...
700rb-ii & 1001rb-ii quick start/tech talk quick start connect your cabinets: connect your gk bi-amp equipped or standard speaker cabinets to the ¼” or speakon outputs as described on page 7. Initial front panel control settings: set all eq and boost controls to 12 o’clock. All other knobs should be...
6 700rb-ii & 1001rb-ii front panel features 2 3 6 7 8 1 4 5 15 16 9 10 11 12 13 18 17 balanced direct out: an electronically balanced low impedance output that you can run to your p.A. System via a mic cable. Ground/lift: used to eliminate hum when c o n n e c t i n g to equipment that is running on...
7 700rb-ii & 1001rb-ii rear panel / bi-amp rear panel features 1 2 3 ac receptacle: standard iec receptacle. The power cord plugs in here. 700w or 480w amp only: ¼” speaker output jacks. Impedances lower than 4 ohms should not be used. Higher impedances such as 8 ohms, 16 ohms, or no load are accept...
700rb-ii & 1001rb-ii amplifiers owner’s manual part # 160-0250-a2 block diagram output power: main amp 1001rb-ii 460w rms@ 8 ohms 700w rms@ 4 ohms 700rb-ii 320w rms@ 8 ohms 480w rms@ 4 ohms horn amp 50w rms@ 8 ohms 75w rms@ 4 ohms audio inputs: instrument input ¼” mono, unbalanced level 0.6v rms w/ ...
