Gallien-Krueger Backline 110 Owner's Manual - Controls
7
B
B
B
B
BA C K
A C K
A C K
A C K
A C KLINE 110 & 112
LINE 110 & 112
LINE 110 & 112
LINE 110 & 112
LINE 110 & 112
11-Master:
11-Master:
11-Master:
11-Master:
11-Master:
Controls output level of the amplifier.
12-Mix:
12-Mix:
12-Mix:
12-Mix:
12-Mix:
Use to plug in a CD player of a second instrument
for teaching.
13-A/B:
13-A/B:
13-A/B:
13-A/B:
13-A/B:
¼” Jack for insertion of standard single pole foot
switch. It Switches from channel “A” to “B”. The “A/B”
switch must be out for this function to operate.
14-Power/Protect LED:
14-Power/Protect LED:
14-Power/Protect LED:
14-Power/Protect LED:
14-Power/Protect LED:
The LED turns red for five seconds
while the amp powers up then turns green when the amp is
ready. Should the amp experience a fault (over heat, over
current) The amp will mute and this LED will go red until
the condition is corrected.
Rear Panel Controls
Rear Panel Controls
Rear Panel Controls
Rear Panel Controls
Rear Panel Controls
15-Power Switch:
15-Power Switch:
15-Power Switch:
15-Power Switch:
15-Power Switch:
Turns the amplifier on or off.
16-AC Input:
16-AC Input:
16-AC Input:
16-AC Input:
16-AC Input:
Standard IEC receptacle.
17-Line Out:
17-Line Out:
17-Line Out:
17-Line Out:
17-Line Out:
Sends a line level signal for use with a direct
box or to a second amplifier.
18-Phones:
18-Phones:
18-Phones:
18-Phones:
18-Phones:
When using headphones, unplug the speaker
cable from the back of the amplifier.
19-Speaker Out:
19-Speaker Out:
19-Speaker Out:
19-Speaker Out:
19-Speaker Out:
It delivers 70 watts into 8 Ohms. Lower
impedances should not be used. Impedances higher than
8 Ohms are acceptable. No damage will result from
operating the amplifier with the speakers disconnected.
Front Panel Controls
Front Panel Controls
Front Panel Controls
Front Panel Controls
Front Panel Controls
1-Input:
1-Input:
1-Input:
1-Input:
1-Input:
A standard ¼” input jack.
2--10dB Pad:
2--10dB Pad:
2--10dB Pad:
2--10dB Pad:
2--10dB Pad:
Press in for active basses.
3-Channel A/B Switch:
3-Channel A/B Switch:
3-Channel A/B Switch:
3-Channel A/B Switch:
3-Channel A/B Switch:
Switches between the overdrive
channel and the normal channel. Can be activated with an
optional footswitch.
4-Gain:
4-Gain:
4-Gain:
4-Gain:
4-Gain:
Controls the amount of overdrive in the “B”
channel. At low settings it provides a smooth distorted
sound. At high levels it will provide full saturation with
long sustain.
5-Level-B:
5-Level-B:
5-Level-B:
5-Level-B:
5-Level-B:
Adjusts the output level of the Overdrive
channel.
6-Level-A:
6-Level-A:
6-Level-A:
6-Level-A:
6-Level-A: Sets preamp gain after the input stage.
7-Contour:
7-Contour:
7-Contour:
7-Contour:
7-Contour:
Cuts the mid-range frequencies while boosting
lows & highs.
8-T
8-T
8-T
8-T
8-Treble:
reble:
reble:
reble:
reble:
Boost and cut at 7kHz+14dB shelving type. Add
or remove edge and definition.
9-Mid:
9-Mid:
9-Mid:
9-Mid:
9-Mid:
Boost and cut at 250Hz +6dB -10dB, “Q Opti-
mized,” band pass type. Works on the main body of your
sound.
10-Bass:
10-Bass:
10-Bass:
10-Bass:
10-Bass:
Boost and cut at 60Hz +10dB, shelving type.
Controls low end punch.
Controls
1 2 3 4 5 6 7 8 9 10 11 12 13 14
15 16 17 18 19