Operating instructions micro lead series.
A word from bob gallien and rich krueger we want to personally introduce you to our labor of love: the microamplifier lead series. They symbolize our continuing effort to make the musician's life easier and more fulfilling. Everything, from the input stage to the speaker outputs, has been redesigned...
Front panel features (1) input jack accepts a 1/4'' phone plug and can be driven by a variety of instruments; however, the internal electronics have been optimized for use with an electric guitar. (2) channel select switch allows you to switch between the lead and clean channels. The rf2 foot contro...
(20) internal speaker on/off switch (combos only) turns the internal speaker(s) on and off. In the "off" position, full power can be taken from the internal power amplifier(s) to drive external speak- ers(see minimum external speaker impedances above). (21) ac receptacle and fuse holder this combina...
Setting up your sound the ml/s and ml/e are capable of producing a wide range of great guitar sounds. Below you will find the basic procedures needed to get started. We have also provided several sample settings that can be used as starting points for various guitar voicings. Getting started lead ch...
Block diagram specifications max input : 1.4vrms output : 70w into 8 Ω per channel (stereo) 140w into 4 Ω (mono) @less than 1% thd headphones : 1.4vrms max into 8 Ω (.25watt) signal to noise ratio: >74db (clean channel referenced to max input; eq flat) input sensitivity : (clean channel) 1.8m vrms @...
Problems: probable causes/solutions: leds light but no signal from speaker outputs, be sure all tone controls and volumes are turned up at headphones, line outputs, or balanced outputs. Least part way. Leds light, tone and volumes turned up but no sound. Auto amplifier shutdown may have tripped. Res...
Gallien-krueger • 2240 paragon dr. • san jose, ca 95131 us: (408) 441-7970 • fax (408) 441-8085 europe: 41.42.234520 • fax: 41.42.239525.
