1. DL manuals
  2. Gallien-Krueger
  3. Musical Instrument Amplifier
  4. Neo 1001/212
  5. Owner's Manual

Gallien-Krueger Neo 1001/212 Owner's Manual

Summary of Neo 1001/212

  • Page 1

    Owner’s manual.

  • Page 2: Introduction

    2 neo series bass combo amplifi er congratulations your purchase of a new gallien-krueger amplifi er is surely the result of much careful consideration on your part. For our part, we at gallien-krueger are pleased that you chose us, and are determined that you will be a satisfi ed customer. In choosing...

  • Page 3: Table of Contents

    3 neo series bass combo amplifi er table of contents s a f e t y i n f o r m a t i o n . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 q u i c k s t a r t . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 front panel controls.............

  • Page 4: Safety Information

    4 neo series bass combo amplifi er safety information please read all enclosed safety precautions before connecting or operating this product. Verify line voltage and amperage: your new amplifi er has been factory confi gured for use with the following: 120 volt/60hz 15 a circuit for usa/canada. 230 vo...

  • Page 5: Quick Start

    5 neo series bass combo amplifi er lock n’ roll transport system: the lock n’ roll transport system is designed for quick and easy rolling of the combo on fl at surfaces such as carpet, fl ooring, pavement, etc. To engage the lock and roll handle, slide the locking latch (below the handle) to the right...

  • Page 6: Front Panel Features

    6 neo series bass combo amplifi er front panel features front panel features 1) balanced direct out: an electronically balanced low impedance output that you can run to your p.A. System via a mic cable. 2) ground/lift: used to eliminate hum when connnecting to equipment that is running on a different...

  • Page 7: Rear Panel Features

    7 neo series bass combo amplifi er rear panel features 20) woofer hi-cut: cuts frequencies above 5khz from the woofer output. 21) effects send: when used, the signal path is in-series, meaning all of the signal goes through the effects loop. 22) effects return: returns the effects loop signal to the ...

  • Page 8: Horn Bi-Amp System

    8 neo series bass combo amplifi er horn bi-amp system horn bi-amp mode: this mode requires a gk horn bi-amp compatible bass cabinet. Use a properly wired four-conductor speakon cable to connect to your cabinet. Set the switch on the back of your gk hba compatible enclosure to bi-amp. In this mode, th...

  • Page 9: Sample Settings

    9 neo series bass combo amplifi er sample settings sample settings: your gk amplifi er is versatile in its sound and tone. Below are a few suggested amp settings that can be used as starting points to defi ne your own sound. Note: at higher playing levels the contour should be set lower for mid-range c...

  • Page 10: Tech T

    10 neo series bass combo amplifi er tech talk your gk amplifier is designed to be flexible and user-friendly for maximum performance. This is accomplished through these important features: high current capability: when a power amplifi er is pushing a speaker cone and it needs to reproduce a high-power...

  • Page 11: Tech T

    11 neo series bass combo amplifi er horn bi-amp operation: bass players have always liked the growl they get from a slightly overdriven poweramp. The problem is that growl sounds great through woofers but will destroy the horn (tweeter). In a typical fullrange system, there is no way to get that grow...

  • Page 12

    Neo series bass combo amplifi er neo series bass combo amplifi er owner’s manual part # 160-0260-a1 block diagram output power: main amp neo 1001/212 460w @ 8 ohms 700w @ 4 ohms neo 700/112 320w @ 8 ohms 480w @ 4 ohms horn amp 50w @ 8 ohms 75w @ 4 ohms audio inputs: instrument input ¼” mono, unbalance...