Gallo A’DIVA Owner's Manual

Summary of A’DIVA

  • Page 1

    A’diva owner’s guide.

  • Page 3

    Contents introduction optional accessories and mounts initial set up detailed set up placement of speakers specifications and warning technical support and warranty 3 4 5 6 7 8 9 10

  • Page 4

    Introduction thank you for choosing gallo acoustics loudspeakers. Please take the time to read and understand this guide thoroughly before installing your loudspeakers. This will ensure that you achieve optimal performance without the risk of causing damage to your speakers or amplifier. 4 box conte...

  • Page 5

    Optional accessories available from your dealer, or directly from www.Galloacoustics.Com 5 wall mount the wall mount is compatible with all micro and a’diva loudspeakers, and is available in black, white and stainless steel finishes. Speaker cable can pass through the mount, allowing for a neat inst...

  • Page 6

    Initial set up please ensure that your amplifier is turned off before connecting the loudspeakers. When connecting speaker cables to your loudspeakers and amplifier, ensure that correct polarity is observed - red (+) terminal on the speaker to the red (+) terminal on your amplifier, black (-) termin...

  • Page 7

    Stereo and 2.1 when using a’diva loudspeakers in a stereo or 2.1 system, employing a suitable crossover or filter will allow you to get the best performance from the speakers whilst protecting them from the lowest frequencies. If a crossover is not used, then you must limit the volume or use a low p...

  • Page 8

    Sub placement of speakers the placement of loudspeakers within a room can have a great effect on the sound of the system - small changes can make significant improvements. • when speakers are placed on the included isolation ring, ensure that they sit near the front edge of the surface to prevent an...

  • Page 9

    Specifications frequency response 76hz to 20khz sensitivity 88 db nominal impedance 8 ohms power handling full range - 50 watts crossover - 100 watts crossover none driver 3” full range dimensions 12.7cm (5”) diameter sphere weight 1.6kg cone material mical polypropylene compound enclosure material ...

  • Page 10

    Technical support should you encounter problems using this product, please contact your dealer or local distributor. You can call gallo acoustics directly for technical support on the following numbers: uk 01555 666883 outside uk +44 1555 666883 united states, canada and south america 866 427 3873 a...

  • Page 12

    Backcover anthony gallo acoustics ltd the inox building caldwellside lanark scotland united kingdom ml11 7sr www.Galloacoustics.Com.