1. DL manuals
  2. Gallo Tech
  3. Car Alarm
  4. GTS-3RS
  5. Operation & Installation Manual

Gallo Tech GTS-3RS Operation & Installation Manual

Manual is about: Keyless RFID Push Button Start & Security System

Summary of GTS-3RS

  • Page 1

    © copyright gallo technologies. All right reserved - 1 - 061515v54rs operation & installation manual (v- 55rs) keyless rfid push button start & security system keyless model # gts-3rs (with remote start) for automatic transmission only disclaimer: this installation manual is designed for the profess...

  • Page 2: Important:

    © copyright gallo technologies. All right reserved - 2 - 061515v54rs important: read all instructions before installation gts-3rs has been designed to eliminate the need for an ignition key to unlock, start and stop the vehicle, and provide a high level of security. Gts-3rs makes use of a sophistica...

  • Page 3

    © copyright gallo technologies. All right reserved - 3 - 061515v54rs positive trigger door lock systems send a positive (+12v) pulse to existing factory relays to lock and unlock the vehicle doors.  electric vacuum pump: pre-‘95 mercedes-benz and audi (figure 5 page 14)  reverse polarity: many for...

  • Page 4

    © copyright gallo technologies. All right reserved - 4 - 061515v54rs  if the system has been triggered while in the armed mode, the siren will chirp and the parking lights will flash four times, when the unlock button is pressed. B.) unlock only (when vehicle occupied)  when the ignition is on, an...

  • Page 5

    © copyright gallo technologies. All right reserved - 5 - 061515v54rs to turn acc, ign 1and ign 2 on/off with no engine start. Press “start stop engine” button and hold for 1.5 sec. Without pressing the brake/clutch peddle, acc, ign 1 and ign2 will turn on and the engine will not start. To turn acc, ...

  • Page 6

    © copyright gallo technologies. All right reserved - 6 - 061515v54rs remote start setup: installer must determine if voltage or tach rpm detection is to be used. Both methods will work in most vehicles; however the tach signal method requires additional setup and the availability of an appropriate t...

  • Page 7

    © copyright gallo technologies. All right reserved - 7 - 061515v54rs gts-3rs has numerous user programmable features that can be enabled or modified according to user’s preferences. This section explains each of the user configurable functions. See sec. 1.6 “key fob & programming function set-up opt...

  • Page 8

    © copyright gallo technologies. All right reserved - 8 - 061515v54rs 9. Auxiliary output (door unlock option): unlock doors (default) when the auxiliary output is activated the central doors will also unlock. Do not unlock doors (optional) when the auxiliary output is activated the central doors wil...

  • Page 9

    © copyright gallo technologies. All right reserved - 9 - 061515v54rs b. Function programming: 1. System must be in disarm mode (green “start/stop engine” button led flashing). 2. Press valet switch 5 times, hold on the 5 th press for over 5 seconds, parking lights will flash 2 times. 3. According to...

  • Page 10

    © copyright gallo technologies. All right reserved - 10 - 061515v54rs figure 1 1.7 installation instructions.

  • Page 11

    © copyright gallo technologies. All right reserved - 11 - 061515v54rs figure 1 option 1 – the user has the option of keeping the original ignition switch or completely removing it. If the ignition switch is kept operational, do not cut the wires and the vehicle can be started with either the “start/...

  • Page 12

    © copyright gallo technologies. All right reserved - 12 - 061515v54rs 22 pin (black) wire harness (main harness) see figure 1 for pin number and location. Pin 1. (red) parking light pwr. W/15a fuse used to power the parking lights. Connect this wire to bat + 12v. Pin 2. (yellow) parking lights out (...

  • Page 13

    © copyright gallo technologies. All right reserved - 13 - 061515v54rs power door lock connections: determine the door locking/unlocking circuitry that your vehicle is equipped with. Fig. 2 shows the door lock/unlock output relay & pin number configuration of the c3 control module connector. The majo...

  • Page 14

    © copyright gallo technologies. All right reserved - 14 - 061515v54rs figure 4 figure 5 reverse polarity ul l + c3 22 pin black blue/red nc-2 blue/white com-2 blue/yellow no-2 green/red nc-1 green/white com-1 green/yellow no-1 3 4 5 6 7 8 + 12v bat lock unlock figure 6.

  • Page 15

    © copyright gallo technologies. All right reserved - 15 - 061515v54rs 3 pin (red) wire harness - hf antenna the hf antenna is used for the high frequency receiver that operates the remote access functions such as remote door locking, and car locating. For maximum range the antenna should be mounted ...

  • Page 16

    © copyright gallo technologies. All right reserved - 16 - 061515v54rs attempting to drive the vehicle. Reconnect the battery and thoroughly test all starting functions. If the key fobs are not detected by the control module, then re-learn both key fobs. See sec. 1.6 (a) for code learning instruction...