Summary of GCS-2200E
Page 1
Electric chain saw instruction manual gcs-2200e.
Page 2
2.
Page 3
3.
Page 4
4.
Page 5
5.
Page 6
6.
Page 7: Pictogram And Explanation
7 pictogram and explanation caution! Read the instruction manual and follow the warning and safety instructions! Always switch off the appliance, disconnect the power and wait till the machine comes to a standstill prior to maintenance, cleaning or repair work! Caution! Always wear eye protection an...
Page 8
8 it starts up. • hold the chainsaw firmly in both hands when working with it. • the chain saw must not be operated by children and young people. The only exception to this prohibition is young persons of 16 years and over who can use the chain saw under supervision as part of their training. Lend t...
Page 9: Transporting The Chainsaw
9 • do not use the chainsaw to remove or similar objects. • when lopping off branches, the chain saw should be supported wherever possible against the trunk, do not cut with the tip of the guide bar (risk of kick-back! See fig. 7). • leave branch lopping work should be carried out by trained personn...
Page 10: Assembling Bar & Sawchain
10 10 contents of the oil tank during sawing work by checking the oil gauge (c). Close the oil tank cap tightly and wipe away any spills. The chainsaw is supplied without oil in tank and it must fill up when first operation. The tank capacity is approx. 150 ml using low viscosity lubrication oil. As...
Page 11: Chain Lubricants
11 11 clearance of at least 20 cm. If you now see growing traces of oil, the chain lubrication system is working correctly. If there are no traces of oil at all, try cleaning the oil outlet (fig 2, a), the upper chain tensioning borehole and the oil duct, or contact your customer service. Check ever...
Page 12: Chainsaw Protection
12 12 chainsaw protection never use the chainsaw in the rain or in damp conditions. If the extension cable is damaged, pull the plug out of the power socket immediately. Never work with a damaged cable. Check the chainsaw for damage. Before using your tool again, check the safety devices or any slig...
Page 13: Maintenance And Cleaning
13 13 the chain saw may be used to fell only trees which are smaller in diameter than the length of the motor still running. If the saw chain gets jammed, release it using a wooden wedge. Remember: danger zone: falling trees can bring down other trees with them. The danger zone is therefore twice th...
Page 14: Storage
14 14 storage cutting lenght max. : 400 mm this application should be stored in a dry and cutting speed : 14 m/s clean room and out of reach of children. Oil tank capacity : 150 ml during extended periods of storage, during the chain brake time : 0.15 sec. Winter for example, ensure that chainswa is...
Page 15: Troubleshooting
Troubleshooting fault cause remedy motor does not run no electricity check socket, cable and plug. Damaged cable: have repaired by customer service. It is prohibited to patch the cable with insulating tape . Damaged switch have to be replaced by a customer service workshop. Chain brake see section "...
Page 16: Explosion Drawing
Explosion drawing 16.
Page 17: Parts List
Pos. Description 35 chain wheel 36 retaining ring 10 37 claw stop 38 oil tank cap complete 39 oil tank 40 housing right section 41 locking block complete 42 guide bar cover 43 spring 44 chain tension knob complete 45 screw 46 chain cover 47 saw chain 48 guide bar 49 locking block parts list pos. Des...