Gama Garden GT-35 Instruction Manual - page 12
Possible operating failures and method of repair
In case of any possible failure, use the information found in the table for repair.
Failure
Cause
Method of repair
The engine cannot
be started.
There is no petrol in the fuel tank.
Fill the fuel tank up with clean fresh, lead-free petrol
.
The petrol is old.
Drain the old petrol from the fuel tank and fill it with clean
fresh, lead-free petrol.
The engine is cold. The control of the
carburettor air valve is in
“RUN” (“Fully
open”) position.
Put the air valve control in
“CHOKE” (“Fully closed”)
position.
The fuel cock lever is in
“OFF” position.
Put the fuel cock lever in the
“ON” position.
The cap of the high-voltage cable is not
attached on the spark plug.
Attach the cap of the high-voltage cable on the spark plug.
The spark plug has become contaminated or
failed.
Clean and if necessary replace the spark plug. Check the
free distance between the electrodes.
The engine does
not
smoothly
operate.
The air valve control is set in the wrong
position.
Set the air valve control in the
“RUN” (”Fully open”)
position.
There is an improper contact between the
spark plug and cap of the high-voltage cable.
Attach thoroughly the cap of the high-voltage cable onto
the spark plug.
Old petrol. There is water and dirt in the fuel
system.
Drain the old petrol from the fuel tank and fill it up with
clean, fresh, lead-free petrol.
Contaminated air filter.
Clean or replace the air filter.
Blades do not
rotate
Blades are blocked by stones or larger soil
pieces.
Stop the engine and remove cap of the high-voltage cable
from the spark plug. Clean the blades.
The clutch cable is wrongly adjusted.
Adjust the clutch cable. See the section:
«Adjustment of
clutch cable
».
High
level
of
vibration
Fixation of blades has loosened or blades
have got damaged.
Stop the engine immediately and remove the cap of the
high-voltage cable from the spark plug. Replace failed
components.
Fixing screws have come loose.
Stop the engine immediately and remove the cap of the
high-voltage cable from the spark plug. Tighten or replace
the bolts.
ATTENTION:
For the clearing of faults not treated above, contact the authorised service repair shop
.
The manufacturer reserves the right to modify the cultivator structure without previous notification for the improvement of
consumer characteristics.