Gamber Johnson 7160-0564 Installation Instructions Manual

Summary of 7160-0564

  • Page 1

    Product mounting disclaimer gamber-johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage of any nature arising directly or indirectly as a result of the improper installat...

  • Page 2: Installers

    Important safety information for installers safety is dependent on the proper installation and servicing of this power cradle. It is important to read and follow all instructions before installing this product. To properly install gamber johnson's power cradle you must have a good understanding of a...

  • Page 3

    Mounting the cradle and power cradle this cradle and power cradle is designed to be used with a variety of gamber johnson mounting systems. Installation instructions for gamber johnson products are provided with each individual product. This cradle and power cradle supports the amps and nec hole pat...

  • Page 4

    Step: 5 re-attach mounting bracket to the cradle and power cradle using the same screws removed in step: 2. Torque to 7 in-lbs. See figure: 6 step: 6 screw together the max3 into its mating part that is attached to the pole. See figure: 7 step: 7 unlock and press the button and swing open the top la...

  • Page 5

    Figure:11 figure: 10 step: 10 swing the cable assembly towards the back and upward. See figure: 11 step: 9 identify the location of the power jack. It is located on the left hand side of the dock at the base of the unit as you are facing the front of the setup. Insert power plug into the jack. See f...

  • Page 6: Inserting The Computer

    Inserting the computer pg 6 when inserting the fz-x1 (-e1) computer 1. It is recommend to shut down the computer completely. Open cradles and power cradle's top latch by 2. Depressing the lock button and lifting top latch from the front and rotating it backwards. When inserting the fz-x1 (-e1) compu...

  • Page 7

    This device complies with part 15 of the fcc rules. Operation is subject to the following two conditions. (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interfernece that may cause undesired operation. Certifications: en 55022...