Gamma 8800 Els Owner's Manual - Mounting The Frame
17
Adjusting the Frame Support Slide
Center the racquet over the Mounting
Stands. Press the quick release button
on the Mounting Stand, located below
the Shoulder Support Knob, and lock the
Frame Support Slide into one of the three
positions depending on the shape and
head size of the racquet. For larger head
sizes position the Frame Support closer to
the Mounting Stand and further away for
smaller head sizes. Check to make sure
the quick release lock is fully seated in the
groove on the Frame Support hex shaft.
Tighten the Frame Supports on the racquet
by turning the Mounting Stand Adjustment
Knob at either end of the Turntable until
they are snug.
Frame Shoulder Support Adjustment
The Shoulder Supports are designed to rotate
and can be adjusted to provide maximum
support to the racquet frame. Rotate the
Shoulder Support so that the pads contact
the frame squarely when the arms are closed
against the racquet.
Mounting Stand Adjustment
To adjust the spacing between the Mount-
ing Stands, turn one of the knobs located
at either end of the Turntable. There is an
arrow on the face of each knob indicating
the turning direction that will “Tighten” the
mounting points and move the Mounting
Stands further apart to bring the posts of the
Frame Support Slides closer to the inside
surface of the racquet head. Turning the
knobs in the opposite direction will move
the Mounting Stands closer together. When mounting a racquet, adjust the Mounting Stand
spacing until the posts of the Frame Support Slides fi t inside the head of the racquet. Lower
the racquet over the posts and adjust the mounting stands until the posts just make contact
with the inside surface of the racquet head at its center points located at 6 and 12 o’clock.