Gamma sports 200 waterfront drive pittsburgh, pennsylvania 15222 phone: 800.333.0337 fax: 412.323.0317 visit our website at www.Gammasports.Com copyright 2012 gamma sports - all rights reserved mman-30 (mpels-12) owner’s manual issue 3 - november 2012 els stringing machine.
2 els owner’s manual limited warranty gamma sports (gamma) warrants to the original purchaser that the progression els stringing machine (“equipment”) purchased is free from defects in materials and workmanship for a period of fi ve (5) years from the date of original purchase for mechanical parts a...
18 mmp11-16 #324 foot pedal switch mbfc badm floating clamp mbfs-14 badm head frame supp mbmss-11 badm mounting sys upg mgsmc machine cover mpg starting clamp mps cleaning stone mpxfs floor stand mtc calibrator sgsm stringer’s mat parts list 5 rubber foot 6a cap screw- m8x30 9 washer- m8 144 shoulde...
4 assembly instructions string clamp installation the post of the string clamp and tube of the string clamp base are treated with grease to provide protection against corrosion during shipping. Remove any excessive grease with a clean cloth prior to use. The post and tube may also be cleaned with is...
16 troubleshooting tips care & cleaning with time and use, the clamping surfaces of your machine may become oily or dirty and result in string or clamp slippage while stringing. Periodic cleaning of the string clamps, string clamp base and string gripper is recommended. Knife sharpening stones work ...
6 control panel functions and features single digit (1-9) memory led display three digit (xx.X) tension setting display or string length led display string length meter button - feature is currently not available. Lbs/kgs button - changes tension display from lbs to kgs. Each press of the button tog...
14 calibration tension calibration procedure each stringing machine has been checked and calibrated at the factory using accurate load sensing devices to ensure that the machine pulls at the correct tension. However, if you suspect that your machine may not be pulling at the correct tension you can ...
8 securing the frame shoulder clamps lock the shoulder supports in position by turning the knob at the base clockwise. Repeat the adjustment procedure for the remaining support post. Re-tighten all of the frame supports in the same order as before. Do not overtighten any of the supports as racquet d...
12 additional features turntable brake the turntable may be locked in any position. Rotate the lever to the right to lock the turn- table and to the left to release the turntable. Badminton shoulder support protec- tion pad installation slide the badminton shoulder support cover over the shoulder su...
10 to tension a string, push the tension switch or the foot pedal. The string gripper will ro- tate and slowly apply tension to the string. When the set tension has been attained, the gripper will stop rotating and the display will fl ash. As the tensioned string stretches, the gripper may rotate in...
