Gamma Yealink W52P Full User Manual - page 17
© Gamma 2014. All rights reserved. Confidential.
LED Status
The DECT repeater has one LED indicator describing the repeater operations. The following table provides
instructions on repeater operations and LED indications:
LED
Indication
Operation
Off
Power off
Red
Slowly flashes
Unregistered, searching for base station
Red
Double flashes
Searching for base station in the registration
mode or performing registration procedure.
Red
Steady on
Registered to base station, ready for use
Red
Shortly flashes
Attempting handset connection
Registering a repeater
The repeater can register to the base station in two ways:
Auto Registration
Manual Registration
Note: The “Repeater Mode” must be enabled on the base station. In order to do that, go to Main Menu
Settings System Settings Repeater Mode Change
Auto Registration
To register a repeater automatically:
Switch on the repeater and check if the LED indicator on the repeater double flashes. If the LED
indicator does not double flash, you need to de-register the repeate
r first. Please refer to “De-
registration
”. If the LED indicator double flashes, go to next step
Switch off the repeater (disconnect the power adapter).
Set the base station in registration mode. Long press the paging key on the base station till the first
LED flashes.