Gamut GamuT “L User Manual

Summary of GamuT “L

  • Page 1

    The gamut “l” loudspeakers user manual.

  • Page 2

    1.

  • Page 3

    Indhold every musical note… . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 3 an introduction 1.What’s in the box?. Page 4 • unpacking • mount the spikes 2. Mounting instruction . . . . . . . . . . . . . . . . . . . . . . . . . ....

  • Page 4

    3 every musical note… an introduction congratulations you have just invested in one of the finest loudspeakers available! Years back we chose the word “gamut” for our products, because “gamut” in latin means "the entire range of musical notes”. The gamut name is therefore the perfect fit to our phil...

  • Page 5

    4 what’s in the “box”? Unpacking you have at this point successfully unscrewed the cover of the wooden transportation box, because you are now reading this manual! L3, l5 & l7 turn the wooden box upside-down so the opening is facing downwards and gently pull the wooden box upwards, so the inner card...

  • Page 6

    1. 3. 4. 2. 5. 6. 5 mounting instruction mounting & using the spikes: (l5 & l7) open the bag enough to attach the front and rear stainless steel rails as shown in picture (1) below and screw them tightly to the base of the speakers with six screws for each rail. • take a spike and screw on the small...

  • Page 7

    6 stay connected connecting to your amplifier the gamut l series speakers are equipped with two pairs of terminals placed on the aluminium panel on the rear side of the speaker. The lower pair is for low frequency input, and the higher pair is for the high frequency input. Red is the positive input ...

  • Page 8

    7 bringing them to life running in why running in? In the first hours of operation the characteristics of the materials used in your loudspeakers will change dramatically, so actually when you get your speakers they are off spec! A run in period therefore is essential before you evaluate the perform...

  • Page 9

    8 • we recommend the following minimum listening distances: l3: 8’ or 2,5 m. L5: 10’ or 3 m. And the l7: 12’ or 3,5 m • distance from the side wall should be as big as possible, and a minimum of app. 30" or 75 cm. (measured from the centre of the tweeter) • distance from the rear wall must be a mini...

  • Page 10

    9 technical specifications: l3: high frequency driver 38mm (1,5”) ring radiator, sd-2 neodymium motor, non-resonant aluminium chamber, multiple chamber low compression design, machined aluminum faceplate and stainless steel phase plug low/mid frequency driver two 180mm (7”) bass/midrange, powerful v...

  • Page 11

    10 many years of enjoyment maintenance: clean the cabinet by using a soft and dry cloth. If the cabinet is very dirty, use a small amount of all-purpose cleaner like washing-up liquid diluted with water. Use as little fluid as possible to avoid the risk of spilling on the membranes. Do not clean the...

  • Page 12

    Oesterled 28 a · dk 4300 holbaek, denmark phone int. +45 70 20 22 68 · fax int. +45 59 43 97 26 e-mail: gamut@gamutaudio.Com · www.Gamutaudio.Com your comments are always welcome we welcome any opinions that you may have, both positive and negative; this helps us to produce even better products in t...