Time lapse vcr before connecting, operating, or adjusting this product, please read this instruction booklet carefully and completely. Model: ctr-4024(b) owner’s manual.
Warning : to reduce the risk of fire or electric shock, do not expose this product to rain or moisture. If you pour a cold liquid into a glass, water vapor in the air will condense on the surface of the glass. This is moisture condensation. Moisture conden- sation on the head drum, one of the most c...
3 contents features introduction features/contents . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 preparation control names and locations . . . . . . . . . . . . . . . . .4-6 installation/vcr to monitor and ccd camera connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
4 control names and locations prep ara tion front 1. Time/cnt/rem button to switch among the clock, tape counter and tape remaining time. 2. V-pos button to move the position of the time/date display in the vertical direction. 3. Timer button to set timer recording. 4. H-pos button to move the posit...
5 prep ara tion control names and locations (cont’d) terminal signal level in/out 1. Alarm in input 2. Alarm out output 3. Alarm reset input 5. Series in input 6. Series out output 7. Warning out output 8. Trigger out output 10. Low tape out output 11. 1-shot rec in input 4, 9, 12. Gnd common v ih v...
6 prep ara tion alarm h series timer index p.Fail k.Lock repeat rec indicator panel 1. Time lapse vcr time indication 2. Alarm indication (alarm rec on indication) 3. Series indication 4. Record indication 5. Timer indication 6. Cassette indication 7. Index indication 8. Power failure indication 9. ...
7 prep ara tion installation vcr to monitor and ccd camera connection • connect your vcr’s audio/video output jacks to the a/v input jacks on back of your monitor. If your monitor does not have a/v input jacks, exchange the monitor or tv for one with a/v input jacks. • connect the ccd camera to vcr’...
8 prep ara tion multiplexer connections if the multiplexer has two output terminals (monitor out, pb out), connect monitor to the pb out terminal if you want to see the playback picture. To use the multiplexer and trigger function properly, refer to the multiplexer instruction manual. How to connect...
