Ganz ZN-DNT350VE Quick Installation Manual
2010/2‐1
1
ZN-DT350VE/ZN-DNT350VE/ZN-DWNT350VE
Quick Installation Guide
This manual has been designed to guide you through basic settings of your IP devices, such as installation and
configuration for using them.
Step1. . Assemble and install IP device
Manual adjustment for 3‐axis movements
Before installation, make a manual adjustment on the inner liner. Perform 3‐axis movements manually by
turning the inner liner to different directions as above, and check if it moves properly.
1)
Connect the LAN cable and power
supply cable with the camera. For the
detailed information, please refer to
the Step2.
2)
Place the installation template
(which is included in the package) on
the ceiling.
3)
Drill three holes on the template and
insert anchor blocks into the holes.
Fasten the camera with screws.
4)
Put the dome cover on the main
body of the camera. Make sure the
main body and the cover fit each other
into place.
5)
Fasten the cover with screws.
When assembling the main body of the
camera
and its dome cover, make sure they
fit each other into place.
The
camera
may fall off the ceiling even after the proper installation and mounting.
To prevent any accident, make sure the ceiling is firm and stable enough to support
the
camera
. If any reinforcement is needed, consult with your safety personnel and
proceed with the installation.
Caution
!