Ganz ZN-DNT350VP(N)E Installation Manual - page 16
ZN‐DT350VE/ZN‐DNT350VE/ZN‐DWNT350VE Installation Guide
2010/2‐1 03A.02
16
6.2.2.View video using IP address
View the live video on a web page using your IP device and its IP address. To have the correct
IP address ready and use it on a web page:
1. Convert a MAC address to an IP address or check the IP address on the ZNS‐GIT IPAdminTool.
(The MAC address is attached on the side or bottom of the device.)
2. Open a web browser and enter the IP address of the device.
3. Click Continue to this website on the Security Certificate Alert page.
4. Click pop‐up blocked and install the ActiveX control as below. You need to install the ActiveX
for displaying the images.
5. Wait for a few seconds while the web page loads. The live video is displayed.
6.3. Reset
1. While the device is in use, press and hold the Reset button.
2. Release the Reset button after 3 seconds.
3. Wait for the system to reboot.
6.4. Factory Default
1. Disconnect the power supply from the device.
2. Connect the power to the device with the Reset button pressed and held.
3. Release the Reset button after 5 seconds.
4. Wait for the system to reboot.
The factory default settings can be inferred as follows:
IP address:
192.168.xx.yy
Network mask:
255.255.0.0
Gateway:
192.168.0.1
User ID:
root
Password:
pass
MAC address = 00‐1C‐B8‐C0‐14‐B1 → IP address = 192.168.20.177
the Hexadecimal number to Decimal number.