- DL manuals
- Ganz
- Security Camera
- ZN-PT series
- Installation Manual
Ganz ZN-PT series Installation Manual
Summary of ZN-PT series
Page 1
Integrated high speed dome camera outdoor installation guide version 3.6.
Page 3: Preface
Preface information given in this manual was current when published. The company reserves the right to revise and improve its products. All specifications are subject to change without notice. Notice this manual provides installation information for the outdoor integrated high speed dome camera. To ...
Page 4
Installation guide ii this symbol on the product or on its packaging indicates that this product shall not be treated as household waste in accordance with directive 2002/96/ec. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipmen...
Page 5: Warnings And Cautions
Installation guide iii warnings and cautions • handle the camera carefully do not abuse the camera. Avoid striking, shaking, etc. The camera could be damaged by improper handing or storage. • installing electricity wiring carefully ask qualified personnel of electrical wiring for the installation. P...
Page 6: Table Of Contents
Installation guide iv table of contents 1. Introduction................................................................................................................1 2. Standard package contents .....................................................................................2 3. Camera setup...
Page 7: Introduction
Installation guide 1 1. Introduction with weather resistant feature, the integrated high speed dome camera is applicable to outdoor installation. The network speed dome camera transmits digital video and audio data using wire connection. Live video can be monitored and recorded from window-based com...
Page 8: Standard Package Contents
Installation guide 2 2. Standard package contents before proceeding, please check the box contains the items listed here. If any item is missing or has defects, do not install or operate the product and contact your dealer for assistance. Dome camera with outdoor mount kit data cable for power suppl...
Page 9: 3.1
Installation guide 3 3. Camera setups and cable connections before installing or connecting the dome camera, please refer to this section and complete preparations for dome camera setups and various switch settings. 3.1 preparations for dome camera setups the following installation procedure is for ...
Page 10
Installation guide 4 step 4 attach the dome cover to the camera body. Before doing that, apply some lubricant on the cover’s water-proof rubber to make the installation process smoother. Note that the tiny protrusion on the cover must align with one of the four holes on the camera body. Step 5 gentl...
Page 11: 3.2
Installation guide 5 3.2 dome camera setups before connecting the dome camera to other devices of cctv system, please complete the dome camera’s id and communication switch settings. These switches are located on the bottom of the dome camera. 3.2.1 switch/connector definition please refer to the di...
Page 12: 3.3
Installation guide 6 3.3 cables and connections the dome camera is supplied with one integrated 22-pin data cable for connecting with the power, video, and rs-485/audio input & audio output cables. Please read the following sections thoroughly before making connections. 3.3.1 cable requirements for ...
Page 13: 3.3.3
Installation guide 7 3.3.3 22-pin connector definition with the 22-pin connector, installers can simply connect the power, video and rs-485 cables to the dome camera at once. Particularly, the alarm pins are serviceable for connecting alarm input and output devices, such as alarm sensors, sirens or ...
Page 14: 3.3.5
Installation guide 8 3.3.5 cable wiring and connection users may need to conduct cable wiring when: (1) connecting self-provided cords to the connector housing instead of using the equipped data cable or (2) connecting alarm input and output devices. The table follows will illustrate the way to wire...
Page 15: 3.3.6
Installation guide 9 3.3.6 ethernet cable connection connect one end of the cat 5 ethernet cable to the rj-45 connector of the network speed dome camera, and the other end of the cable to the network switch or pc. Note: in some cases, you may need use an ethernet crossover cable when connecting the ...
Page 16: Dome Camera Installation
Installation guide 10 4. Dome camera installation basing on user’s installation environments, the dome camera can be installed on ceiling, on wall or on pole. In the following section, various dome camera’s installation accessories, installation methods and installation procedures will be described ...
Page 17: 4.2
Installation guide 11 4.2 optional accessories dome camera accessories sunshield height: 129.5 mm (5.05 inches); diameter: 190 mm (7.48 inches); 0.15 kg (0.33 lbs) vandal proof/ smoke cover diameter: 147 mm (5.8 inches) vandal proof cover smoke cover security screw set (equipped with vandal proof co...
Page 18
Installation guide 12 mounting accessories standard pendent mount white; 348×104×138.6 mm (13.7×4.1×5.5 inches); 1.5 kg (3.3 lbs); diameter: 45 mm (1.8 inches). Supplied with m8x12 screw x1, spring washer-8 x1, pendent tube washer x1, rubber washer-8 x1 and sponge x2. Compact pendent mount 184×104×1...
Page 19
Installation guide 13 swan tube for mounting with swan tube. White; iron, dimension: 835 x 300 mm (32.9×11.8 inches); diameter: 45 mm (1.8 inches); weight: 3.8 kg (8.4 lbs); supplied with pendent tube washer x1, rubber washer-8 x1, waterproof rubber x1, spring washer-8 x1 and m8x12 screw x1. Corner ...
Page 20
Installation guide 14 pole thin direct mounting 232(l)×136(w)×60(d) mm (9.1×5.4×2.4 inches); diameter: 112~140 mm (4.4~5.5 inches); 0.7 kg (1.6 lbs). Supplied with stainless steel straps x4, m8x16 screw x4, washer x4 and spring washer-8 x4. Pole wide direct mounting 270(l)×170(w)×60(d) mm (10.6×6.7×...
Page 21
Installation guide 15 corner wide box mounting 232(l)×234(w)×210(d) mm (9.1×9.2×8.3 inches); 2.7 kg (6 lbs); supplied with m8x16 screw x4, washer-8 x4, and spring washer-8 x4. Power box can be set inside the wide box. Pole thin box mounting 291(l)×136(w)×242 (d) mm (11.5×5.4×9.5 inches); 3.1 kg (6.9...
Page 22
Installation guide 16 wall box mounting 270(l)×166(w)×95(d) (10.6×6.5×3.7 inches); 2.2 kg (4.84 lbs); supplied with m8x16 screw x4, washer-8 x4 and spring washer-8 x4. Power box can be set inside the wall box. Stainless steel straps for fixing pole direct mounting/pole box on the pole. Length: 700 m...
Page 23: 4.3
Installation guide 17 4.3 ceiling mounting with straight tube the straight tube is available in different length: 25 cm and 30 cm. Package contents: • m8x12 screw x1 • spring washer-8 x1 • pendant tube washer x1 • rubber washer-8 x1 • waterproof rubber x1 items needed: • dome camera • outdoor mount ...
Page 24
Installation guide 18 6) thread the cable(s) through the outdoor mount kit and join the outdoor mount kit to the straight tube with the supplied screws and washers. Then adjust the waterproof rubber to the joint. 7) connect the cable(s) to the dome camera. 8) join the dome camera to the outdoor moun...
Page 25: 4.4
Installation guide 19 4.4 wall mount 4.4.1 swan tube package contents: • m8x12 screw x1 • spring washer-8 x1 • pendent tube washer x1 • rubber washer-8 x1 • waterproof rubber x1 items needed: • dome camera • swan tube and other equipped items (optional accessory) • waterproof rubber (standard access...
Page 26: 4.4.2
Installation guide 20 wall mount: swan tube + indoor mounting kit 4.4.2 compact pendent mount package contents: • rubber washer-8 x1 • pendant tube washer x1 • spring washer-8 x1 • m8x12 screw x1 items needed: • dome camera • outdoor mount kit (supplied) • data cable (supplied) • ethernet cable (net...
Page 27
Installation guide 21 tools needed: • tool for drilling • tool for screwing follow the steps below to mount the dome camera with the compact pendent mount. 1) make a cable entry hole on the wall to recess the cables. Otherwise, users could push up the cable entry board on the compact pendent mount’s...
Page 28: 4.4.3
Installation guide 22 6) connect the cable(s) to the dome camera. 7) join the dome camera to the outdoor mount kit with the supplied m5 screw and washers. Wall mounting: compact pendent mount + outdoor mount kit 4.4.3 standard pendent mount package contents: • m8x12 screw x1 • spring washer-8 x1 • p...
Page 29
Installation guide 23 tools needed: • tool for drilling • tool for screwing follow the steps below to mount the dome camera with the standard pendent mount. 1) make a cable entry hole on the wall to recess the cables. Otherwise, users could push up the cable entry board on the standard pendent mount...
Page 30: 4.4.4
Installation guide 24 4.4.4 wall box mounting package contents: • m8x16 screw x4 • washer-8 x4 • spring washer-8 x4 items needed: • dome camera • outdoor mount kit (supplied) • data cable (supplied) • ethernet cable (network speed dome camera) • standard/ compact pendent mount and equipped items (op...
Page 31
Installation guide 25 4) attach the waterproof rubber to the standard/ compact pendent mount. 5) thread the cable(s) through the outdoor mount kit and join the outdoor mount kit to the standard/ compact pendent mount with the supplied screws and washers. Then adjust the waterproof rubber to the join...
Page 32: 4.5
Installation guide 26 4.5 corner mount 4.5.1 corner standard mounting plate/corner plate mini package contents: • washer-8 x4 • spring washer-8 x4 • m8x16 screw x4 • m8 nut x4 items needed: • dome camera • outdoor mount kit (supplied) • data cable (supplied) • ethernet cable (network speed dome came...
Page 33
Installation guide 27 note: please block the cable entry hole with the supplied sponge to avoid insects entering the pendent mount. See the illustrations in section 4.4.2 compact pendent mount > step 4. 4) attach the waterproof rubber to the standard/ compact pendent mount. 5) thread the cable(s) th...
Page 34: 4.5.2
Installation guide 28 4.5.2 corner thin/wide box mounting package contents: • m8x16 screw x4 • washer-8 x4 • spring washer-8 x4 items needed: • dome camera • outdoor mount kit (supplied) • data cable (supplied) • ethernet cable (network speed dome camera) • standard/ compact pendent mount and equipp...
Page 35
Installation guide 29 4) attach the waterproof rubber to the standard/ compact pendent mount. 5) thread the cable(s) through the outdoor mount kit and join the outdoor mount kit to the standard/ compact pendent mount with the supplied screws and washers. Then adjust the waterproof rubber to the join...
Page 36: 4.6
Installation guide 30 4.6 pole mount 4.6.1 pole thin/wide direct mounting package contents: • stainless steel straps x4 • m8x16 screw x4 • washer x4 • spring washer-8 x4 items needed: • dome camera • outdoor mount kit (supplied) • data cable (supplied) • ethernet cable (network speed dome camera) • ...
Page 37
Installation guide 31 note: please block the cable entry hole with the supplied sponge to avoid insects entering the pendent mount. See the illustrations in section 4.4.2 compact pendent mount > step 4. 4) attach the waterproof rubber to the standard/ compact pendent mount. 5) thread the cable(s) th...
Page 38: 4.6.2
Installation guide 32 4.6.2 pole thin/wide box mounting package contents: • m8x16 screw x4 • washer-8 x4 • spring washer x4, • stainless steel straps x4 items needed: • dome camera • outdoor mount kit (supplied) • data cable (supplied) • ethernet cable (network speed dome camera) • standard/ compact...
Page 39
Installation guide 33 4) attach the waterproof rubber to the standard/ compact pendent mount. 5) thread the cable(s) through the outdoor mount kit and join the outdoor mount kit to the standard/ compact pendent mount with the supplied screws and washers. Then adjust the waterproof rubber to the join...
Page 40: System Expansion
Installation guide 34 5. System expansion 5.1 connecting with power box a power box contains a 24v ac adapter, two terminal blocks (for communication and power) and one alarm board. With an ip66 case, the power box is ideal for outdoor installation environment. Two models are available: 100~115v ac ...
Page 41
Installation guide 35 appendix a: technical specification items 18x model 30x model 36xmodel camera ccd sensor sony ccd optical zoom 18× 30× 36× digital zoom 1~12x variable ntsc 480k effective pixels pal 570k horizontal resolution 650 tvl scanning system ntsc / pal synchronization internal / line lo...
Page 42
Installation guide 36 motion detection on / off wide dynamic range on / off day/night: ir cut filter auto / manual image freeze on / off image inverse on / off 2d on / off noise reduction 3d on / off alarm 4 digital alarm inputs / 1 alarm outputs alarm reaction preset, sequence, auto pan, cruise net...
Page 43
Installation guide 37.