Garden GP00 Installation And User Manual

Other manuals for GP00: Installation And User Manual
Manual is about: Swimming Pool Heat Pump

Summary of GP00

  • Page 1

    Swimming pool heat pump installation and user manual.

  • Page 2: Contents

    Contents i. Use ........................................................................................................... 17 ii. Features .................................................................................................... 17 iii. Technical specifications..............................

  • Page 3: I.  Use

    Thank your choosing our product and your trust in our company. To help you get maximum benefit from this product, please read this instruction manual carefully and operate strictly according to the instructions before starting the machine; otherwise, the machine may be damaged or cause you unnecessa...

  • Page 4: Notice:

    Iii. Technical specifications model gp00 gp01 gp02 gp03 gp04 gp05 gp06 gp07 performance condition: air 26 ℃ ℃ ℃ ℃ , water 26 ℃ ℃ ℃ ℃ heating capacity kw 3.6 5 7 10 13 17 25 26 c.O.P. 5.2 5.3 6.3 6.2 6.3 6.2 6.4 6.5 performance condition: air 15 ℃ ℃ ℃ ℃ , water 26 ℃ ℃ ℃ ℃ heating capacity kw 2.7 3.7 ...

  • Page 5: IV.  Dimensions

    Iv. Dimensions ※ above data is subject to modification without notice. Note: the diagram above is for the dimensions of the heat pump, for technician’s layout reference only. We reserve the right to make improvements periodically without further notice. A b c d e f g h gp00 275 395 266 300 641 260 7...

  • Page 6

    V. Installation instructions 1- schema for plumbing the water pipes (please note: this schematic layout of the pipes is only for reference. ) . Schema 2: heat pump plumbing.

  • Page 7: Electrical Wiring Diagram

    2- electrical wiring diagram note : the swimming pool heater must be connected to the earth rod. Options for circuit breakers and wire specs ※ above data is subject to modification without notice. Model gp00 gp01 gp02 gp03 gp04 gp05 gp06 gp07 rated current a 6 15 15 20 20 25 40 15 breaker rated resi...

  • Page 8: A. Installation

    Note: the above data is adapted to power cord ≤ 10 meters from the power supply .If power cord is ﹥ 10 meters away, the wire diameter must be increased. The signal cable can be extended to 50 meters at most. 3- installation instructions and requirements the swimming pool heater must be installed by ...

  • Page 9

    (leakage operating current ≤ 30ma). 5) the layout of power cable and signal cable should be separated. C . . . . switch on after finishing and double-checking all wiring. Vi. Instructions for use pictograms on the led screen clock time on time off heat.

  • Page 10: Use Of The Display Panel

    1 . . . . use of the display panel a. The display panel shows time when the machine is off; b. The display panel shows temperature of the swimming pool water when the machine is on. 2 . . . . water temperature setting a . available whether the machine is on or off; b . press the key or to set water ...

  • Page 11: Vii.

    And to adjust. After adjusting, press “timer on” and water temperature will be seen. 30 seconds later , the display panel will return to the normal mode; b. Press to set timer off. When the indicator light is on and the time is flashing, press again to set hour. Use and to adjust. Before the flashin...

  • Page 12: Trial

    2 2 2 2. . . . trial a . please start the pump before the heat pump and turn it off after the heat pump, so there is water running through the system throughout operation hours. B . the user should start the pump, making sure the water pressure is correct; set the desired temperature on the thermost...

  • Page 13: . Safety

    Heating effect of the heater cannot be ensured; h. This series of heat pumps can achieve high efficiency between the air temperatures of +15 ℃~ +25 ℃ . I. In case a power cut during operation, the heat pump will stop, and will start up automatically when the the power resumes. 2 2 2 2 . Safety a . p...

  • Page 14: Ix.  Maintenance

    Ix. Maintenance a . “cut off” power supply of the heater before any examination and repair; b. In winter season when you don’t swim: a) cut off power supply to prevent any machine damage b) drain water clear of the machine. C) cover the heat pump to avoid dirt entering c . please clean this heat pum...

  • Page 15: Problem

    X. Trouble shooting for common faults problem reason not a failure a.Noticeable white vaporous cold air or water b.Gurgling sound a.The fan motor stops automatically for defrost. B.Sound from the solenoid valve when starting and ending of defrost. C.During use or just after use, a sound like water f...

  • Page 16: Failure Code

    Failure code no. Failure code failure description 1 ee 1 high pressure protection 2 ee 2 low pressure protection 3 ee 3 low water pressure protection 4 ee 4 a.1 phase machine: failure connection due to loose wire terminal of prot2 on the pc board; b.3 phase sequence protection. 5 pp 1 swimming pool ...