1. DL manuals
  2. Garden Pride
  3. Blower
  4. GP26B
  5. User Manual

Garden Pride GP26B User Manual

Summary of GP26B

  • Page 1

    Hand-held blower user’s manual model: gp26b www.Midlandpower.Co.Uk midland power distribution limited quality service support.

  • Page 2

    - - 1 introduction eb260bn engine blower has been designed and manufactured with superior performance and reliable without compromise to safety or durability. Eb260bn’s high performance engine system is adopted the 2-cycle engines technology marked with power, low displacement and weight. As a profe...

  • Page 3

    - - 2 contents attention statements………………………3 product description……………………… 5 specifications………………………………6 assembling the machine……………………7 mixing fuel…………………………………8 filling the fuel tank…………………………9 starting the machine…………………………12 routine maintenances………………………14 storage………………………………………16 troubleshootin...

  • Page 4

    - - 3 attention staements this manual contains special “attention statements” surrounded by boxes and preceded by the triangular attention symbol important! A statement preceded by the word “important” is one that possesses special significance. Note: a statement proceeded by word “note” contains in...

  • Page 5

    - - 4 · never smoke when working with this machine ·never allow children or anyone unable to fully understand the manual to use this machine ·clothing must be sturdy and snug-fitting, but allow complete freedom of movement— the safety clothing is recommended. ·wear heavy-duty, nonslip gloves, prefer...

  • Page 6

    - - 5 ·danger form rotating impeller! Stop the engine before installing or removing the machine tubes! Never perform any maintenance or assembly procedures on this machine while the engine is running. ·never direct the machine stream toward people or animals! ·operate the machince only at reasonable...

  • Page 7

    - - 6 warning! Do not make unauthorized modifications to this machine specifications model………………………………………eb260bn dimensions(l×w×h)………………355×285×395 engine type……………………………1e34fn cylinder diameter………………………34mm displacement……………………………25.4cc fuel…………………………gasoline/oil mixture 40:1 carburetor…………membrane...

  • Page 8

    - - 7 assembling the machine (1) nomenclature (2)assembly put blow pipe b to the machine put blow a to b by by rotating rotating important! Whether the assembly of blower pipe is proper ornot will influence the stable performance so before operate this machine please make sure that it is properly as...

  • Page 9

    - - 8 mixing fuel fuel requirements □ use only fresh, clean fuel □ use only fuel with an octane rating of 90 or high □ mix all fuel with premium 2-cycles engine oil at a gasoline/oil ratio of 40:1 caution! Never attempt to mix fuel in the machine fuel tank! Always mix all fuels in a clean. Approved ...

  • Page 10

    - - 9 remove the fuel cup warning! Danger of fire and burn injury! □ always use extreme care when handling fuel! Fuel is highly flammable! □ never operate this blower if fuel system components are damaged or are leaking! □ never attempt to refuel the engine while it is running ! □ never attempt to r...

  • Page 11

    - - 10 4. Replace the cap, and wide away any spilled fuel before starting the machine. Starting the manchine warning! The recoil starter can be damaged by abuse! Never operate the machine if the tubes are missing or damaged starting procedure 1. Prime the fuel system by repeatedly depressing the fue...

  • Page 12: If The Engine Dose Not Start

    - - 11 when the engine starts important for maximum vacuum performance and operating life, allow the engine to warm before use. 1. Run the engine at idle speed until operating temperature is reached(2 to 3 minutes) 2. As the engine warms, open the choke gradually by slowly pushing the choke control ...

  • Page 13: Starting A Flooded Engine

    - - 12 warning! Incorrect spark plug installation can result in serious engine damage! Starting a flooded engine 1. Disconnect the spark plug lead, and use the spark plug wrench to remove the plug in a counterclockwise direction. 2. If the spark plug is fouled or is soaked with fuel, clean or replac...

  • Page 14

    - - 13 adjusting enging idle speed 1. Start the engine by following the procedures described on the preceding pages. 2. Run the engine at idle speed until operating temperature is reached (2-3 minutes) 3. Use a screwdriver to adjust the engine idle speed to 3000±200r/min □ turn the idle screw clockw...

  • Page 15: Routine Mainteances

    - - 14 (4) wear a dust mask to reduce the risk of inhalation injures. (5) wear close-fitting clothing to protect your legs and arms. (6) wear hearing protection when operating this machine. (7) never operate the blower if any component parts are damaged, loose, or missing. Using the blower always be...

  • Page 16: Every 50 Hours

    - - 15 replace it with a new one. 3. Wash the element in clean fuel, and squeeze or blow dry. Wash the air cleaner cover in clean fuel, and wipe or blow dry. 4. Install the element and cover, and the tighten the cover retaining screw. Every 10/15 hours 1. Use the spark plug wrench to remove the spar...

  • Page 17: Storage(30 Days Or Longer)

    - - 16 caution! Never allow dirt or debris to enter the cylinder bore! Before removing the speak plug. Thoroughly clean the the spark plug and cylinder head area! Allow the engine to cool before servicing the spark plug! Cylinder tightening or loosening the spark plug while the engine is hot! Incorr...

  • Page 22

    序号 erp编号 数量 序号 erp编号 数量 item erp no. Qty item erp no. Qty 火花塞 rcj6y 化油器垫 spark plug rcj6y gasket,carburetor 螺钉组合 m5x20 化油器总成 bolt m5x20 carburetor comp 缸体 阻风门手柄 cylinder choke handle 缸体垫 空滤器内罩 gasket,cylinder cleaner inside cover 活塞环 阻风门 ring,piston choke 活塞 自攻螺钉 st4×10 piston bolt st4×10 活塞销 8x28 空...

  • Page 24

    序号 erp编码 名称 数量 序号 erp编码 名称 数量 ser.No. Erp no. Part name qty ser.No. Erp no. Part name qty 螺钉 m4×14 油管胶塞 screw m4×14 fuel pipe rubber bung ￠4加大平垫 进油管(l=220) washer 4 inlet fuel pipe 风机网罩 燃油过滤器 safety cover filter cleaner 平垫 油箱盖组合 washer lid assy 扭簧 油门绳 waest sping throttle wrie comp 钢平垫 启动绳轮 washer s...