Ansi z83.26-2007/csa 2.37-2007 gas-fired outdoor infrared patio heaters model : hps-c-sh rona sku number:70005000 owner’s manual important read this manual carefully before assembling, using or servicing this heater. Keep this manual for future reference. Tabletop patio heater r r.
1 contents general safety information....................................... 1 contents breakdown ............................................. Package contents .................................................. 4 4 assembly.................................................................. Portable ...
Danger • explosion - fire hazard • keep solid combustibles, such as building materials, paper or cardboard, a safe distance away from the heater as recommended by the instructions. • provide adequate clearances around air openings into the combustion chamber. • never use the heater in spaces which d...
3 warning • this product is fueled by propane gas. Propane gas is invisible, odorless, and flammable. An odorant is normally added to help detect leaks and can be described as a “rotten egg” smell. The odorant can fade over time so leaking gas is not always detectable by smell alone. • propane gas i...
This outdoor/tabletop heater requires some assembly.Check over the contents to make sure all the parts are available for assembly. Contents: 1. Castle nuts (qty. 3) 2. Reflector 3. Emitter 4. Wire guard 5. Access panel 6. Base 7. Cast iron ring weight 8. M6x20 bolts (qty. 4) 9. 3/16" stainless bolts...
5 assembly step 1 – attach cast iron assembly to base step 2 – attach burner assembly to tank housing step 3 – emitter screen assembly take out all the parts of the tabletop heater. Aim the cast iron at the base holes. Use 4pcs m6x15mm bolts and fix the tank housing to the base & cast iron. Tighten ...
Step 4 – the guard assembly step 5 – the reflector assembly step 6 – gas tank assembly put the guard on the burner through the emitter screen. Put the ends of the guard into the holes of the burner. Put 3pcs washers on each pins of the 60mm length. Put the reflector through the pins and on the washe...
7 1. This portable heater is intended for outdoor use only. Always ensure that adequate fresh air ventilation is provided. 1. Perodically check the whole gas system for leaks. 2. Immediately check for leaks if an odor of gas is detected. 3. Extinguish all open flames during testing or when an odor o...
Troubleshooting if the problem is: and this condition exists: then do this pilot won’t light cylinder valve is closed open valve blockage in orifice or pilot tube clean or replace orifice or pilot tube air in gas line open gas line and bleed it (pressing control knob in) for not more than 1 - 2 minu...
9 . Gas odor with extreme yellow tipping of flame. . Heater does not reach the desired temperature. . Heater glow is excessively uneven. . Heater makes popping noises. Ґ . Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe for use. Cle...
10 receipt and/or invoice. If the unit was received as a gift, please ask the gift-giver to send in the receipt on your behalf, to the below address. Defective or missing parts subject to this limited warranty will not be replaced without registration or proof of purchase. This limited warranty appl...
