Garden Treasures APQ08615 Assembly Instruction Manual - page 4
4
ASSEMBLY INSTRUCTIONS
2 . Attach the leg connector bracket (B) to a leg by
using two 1/4 in. x 30 mm bolts (BB) and washers
(CC). Guide the bolts through the holes in the table
leg and into the pre-drilled holes in the table rim.
Hand tighten only. Repeat for the other three legs.
3. Tighten all bolts using hex bolt driver (EE). Important
note: Tighten each bolt a few revolutions at a time.
We recommend working in a cross corner (X)
fashion, alternating between bolts. This will tighten
the frame evenly by placing equal pressure on all
bolt joints. Do not over tighten. Cover all bolts with
covers (DD) provided.
4. With the help of another person, carefully turn the
table in the upright position. Your table is now
ready for usse.
1. Place the table rim (A) upside down on a flat, non-
abrasive surface. Attach a table leg (C) to the table
rim by using a 1/4 in. x 20 mm bolt (AA) and washer
(CC). Guide the bolt through the hole in the table leg
and into the pre-drilled hole in the table rim. Hand
tighten only. Repeat for the other three legs.
3
Hardware Used
ø 6.5 x 1.0 mm Washer
x 4
AA
1/4 in. x 20 mm Bolt
x 4
CC
Hardware Used
BB
ø 6.5 x 1.0 mm Washer
x 8
1/4 in. x 30 mm Bolt
x 8
CC
Hardware Used
DD
Bolt Cover
x 12
Lowes.com/gardentreasures