Gardena 9852-33 Operator's Manual - 6. Troubleshooting
6. TROUBLESHOOTING
Before you do trouble-
shooting:
1
1
2
2
WARNING! Risk of physical injury!
Cut injury when the product starts accidentally.
v
Slide the protective cover
(1)
over the blade
(2)
before you
do troubleshooting.
To change the grass shear
blade:
2
w
q
0
9
Only an original GARDENA grass shear blade is allowed to be
used. A new blade can be ordered by the GARDENA Service.
1. Push the button
9
and slide the lid
0
downwards.
2. Remove the blade
(2)
.
3. If necessary clean the transmission chamber and lubricate the
excentric drive
q
with some acid-free grease (Vaseline).
4. Turn the excentric drive
q
downwards.
5. Pull the crank
w
on the back side of the blade
(2)
in the middle.
6. Place the new blade
(2)
on the motor unit in such a way that the
excentric drive
q
is inserted in the crank
w
.
7. Slide the lid
0
upwards until it makes a click.
To change the shrub shear
blade:
2
w
q
0
9
e
Only an original GARDENA shrub shear blade is allowed to be
used. A new blade can be ordered by the GARDENA Service.
1. Push the button
9
and slide the lid
0
downwards.
2. Remove the blade
(2)
.
3. If necessary clean the transmission chamber and lubricate the
excentric drive
q
with some acid-free grease (Vaseline).
4. Turn the excentric drive
q
downwards.
5. Pull the crank
w
on the back side of the blade
(2)
downwards.
6. Slide the ring
e
in the middle of the crank
w
.
7. Place the new blade
(2)
on the motor unit in such a way that the
excentric drive
q
is inserted in the ring
e
of the crank
w
.
8. Slide the lid
0
upwards until it makes a click.
20
GB