Ru s gardena ® gb f nl s dk c 1030 plus art. 1862 gb operating instructions water computer f mode d’emploi programmateur d’arrosage nl instructies voor gebruik besproeiingscomputer s bruksanvisning bevattningscomputer dk brugsanvisning vandingscomputer rus Инструкция по эксплуатации Компьютер для по...
2 gb 2. Safety instructions battery : to ensure the water computer runs safely, only a 9 v alkaline manganese battery (alkaline) type iec 6lr61 must be used. In order to stop the water computer from failing because of a weak battery if you are away for a long time, the battery must be replaced when ...
3 gb controls : display levels : the water computer may only be set up vertically with the sleeve nut to the top to prevent water penetrating into the battery compartment. The minimum water output to ensure that the water computer functions correctly is 20 - 30 l / h. For example, at least 10 x 2-li...
4 gb you can change the display level at any time, even during pro- gramming. All the programme data which have been confirmed up to that point with the ok key are stored. Display description 5 weekdays current weekday or programmed (mo), (tu), ... Watering days. 6 time flashes when in input mode fo...
5 gb connect soil moisture or rain sensor (optional) : e j insert battery: 4. Putting your water computer into operation the water computer must only be operated with a 9 v alkali- manganese (alkaline) battery type iec 6lr61. 1. Remove controller e from the housing of the water computer. 2. Insert b...
6 gb to secure your water computer against theft, you can obtain the gardena anti-theft device art. No. 1815-00.791.00 from gardena service. 1. Screw clamp k with screw l firmly to the back of the water computer. 2. Use clamp k e.G. For fixing a chain. It is no longer possible to remove the screw af...
7 gb scheduled watering : 1. Press menu-key twice (not necessary if the current time and day of the week has been entered). Start prog and the hours section flash on the display. 2. Set the watering start time hours with the rotary button (e.G. 6 ) and confirm with the ok-key. Start prog and the min...
8 gb the prog on must be selected so that the watering programme can start. 1. Press the menu button 5 times (not necessary if the programme has been created before). 2. Select the prog on with the rotary button and confirm by pressing ok. The prog ok appears for 2 seconds and then the normal displa...
The watering duration is preset to 30 minutes at the factory. Emergency programme : if no sensor is inserted in sensor-con- trolled watering mode or if the connection cable is faulty, watering will take place every 24 hours. The watering duration depends on the run time but is limited to a maximum o...
10 gb the factory settings are restored. V press man.-key and menu-key simultaneously for 3 seconds. All the lcd symbols are displayed for 2 seconds and the display moves to the normal display. • all the program data are set to zero. • the manual watering period is set to 0 :30 again. • the time and...
11 gb 8. Troubleshooting fault possible cause remedy no display appears battery inserted incorrectly. V check polarity markings match (+ / –). Flat battery. V insert new (alkaline) battery. Temperature on the display display appears after is higher than 60 °c. Temperature has dropped. Manual waterin...
12 gb gardena to connect older gardena art. No. 1189-00.600.45 adapter cable sensors from gardena service gardena for simultaneous connection of from gardena service cable adapter rain and soil moisture sensor 10. Technical data min. / max. Operating pressure : 0.5 bar / 12 bar flow medium : clear f...
70 ru s • Порча в результате замерзания также исключается из обязательств по гарантии. Эта га ран тия про из во ди те ля не ка са ет ся су ще ствую щих тре бо ва ний по га ран тий но му об слу жи ва нию про дав ца. Бы стро из на ши ва ю щие ся де та ли ис клю че ны из га ран тий но го об слу жи ва н...
71 description of the unit : water computer désignation du matériel : programmateur d’arrosage omschrijving van het apparaat : besproeiingscomputer produktbeskrivning : bevattningscomputer beskrivelse af enhederne : vandingscomputer type : art. No.: type : référence : typ : c 1030 plus art. Nr.: 186...
72 deutschland / germany gardena gmbh central service hans-lorenser-straße 40 d-89079 ulm produktfragen: (+ 49) 731 490 - 123 reparaturen: (+ 49) 731 490 - 290 service @ gardena.Com albania cobalt sh.P.K. Rr. Siri kodra 1000 tirana argentina husqvarna argentina s.A. Av.Del libertador 5954 – piso 11 ...
