- DL manuals
- Gardena
- Lawn and Garden Equipment
- C 1060 profi/solar
- Operating Instructions Manual
Gardena C 1060 profi/solar Operating Instructions Manual
Summary of C 1060 profi/solar
Page 1
F nl pl gr gb gardena ® gb operating instructions water computer f mode d’emploi programmateur d’arrosage nl gebruiksaanwijzing besproeiingscomputer pl instrukcja obsіugi sterownik nawadniania gr Οδηγες χρσης Ηλιακ ς Προγραµµατιστς ποτσµατος c 1060 profi / solar art. 1833.
Page 2
2 gb gardena water computer c 1060 profi / solar welcome to the garden of gardena... Please read these operating instructions carefully and observe the notes given. Use these instructions to familiarise yourself with the water computer and its proper use as well as the notes on safety. For safety re...
Page 3: 2. For Your Safety
3 gb intended use please note 10. Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 11. Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 12. Service . . . . . . . . . . ....
Page 4
4 gb cells are not covered over and that the water computer is not stored in a place which is permanently dark. Setting up warning ! The water computer must not be used indoors. V only use the water computer outdoors. The water computer may only be set up verti- cally with the sleeve nut to the top ...
Page 5: 3. Function
5 gb 3. Function this gardena water computer c 1060 profi / solar allows you to water your garden completely automatically any time you choose up to 6 times a day, whether you are using a sprinkler, a sprinkler system installation or a drip-head watering system. Your water computer waters your garde...
Page 6
6 gb displays display description 5 weekdays current weekday or programmed watering days. (mo, tu,...) 6 prog. Program selected (1 to 6). 7 special only for controlling the automatic water distributor art.-no. 1198. 8 ttiimmee flashes when in input mode for the current data (hours, minutes, day of t...
Page 7
7 gb f batt. If the battery indicator begins to flash, the re- chargeable battery (accu) power is low and the watering programs will no longer run. Any valves that are still open are closed again even if the rechargeable battery (accu) power is low. To reset the battery display, remove the re- charg...
Page 8
8 gb insert battery : p 4. Putting your water computer into operation risk of damage to the water computer. A v do not use alkali-manganese batteries. Charging can cause them to leak out over the solar cells. 1. Press unlock button h and pull control unit i out of the water computer housing. 2. Stic...
Page 9
9 gb compile watering plan : the water computer is fitted with a sleeve nut l for taps with g 1 ” (33.3 mm) thread. The adaptor supplied k allows the water computer to be connected to taps with a g 3 /4 ” thread (26.5 mm). Connect water computer to water tap with g 1 ” (33.3 mm) thread : 1. Screw sl...
Page 10
10 gb example : in addition to time-based watering, it is also possible to include the soil moisture or rain in the watering programs. If the soil is moist enough, the program will be stopped, or a program will be prevented from starting. Manual operation via man. On / off is unaffected by this. 1. ...
Page 11: 5. Programming
11 gb to secure your water computer against theft, you can obtain the gardena anti-theft device art. No. 1815-00.791.00 from gardena service. 1. Screw clamp o with screw p firmly to the back of the water computer. 2. Use clamp e.G. For fixing a chain. It is no longer possible to remove the screw aft...
Page 12
12 gb 2. Set the time in hours with the ▲-key (example: 99 hours) and confirm with the o.K.-key. Ttiimmee and the minutes display flash. 3. Set the time in minutes with the ▲-key (example: 3300 minutes) and confirm with the o.K.-key. Ttiimmee and the day of the week display flash. 4. Set the day of ...
Page 13
13 gb 1. Press menu-key twice (not necessary if the current time and day of the week has been entered). Program memory setting 1 flashes. 2. Only if the automatic water distributor is used : select special-function with the ▲-key and confirm with the o.K.-key (continue with step 4). Program memory s...
Page 14
14 gb 5. Set the minutes for starting the watering time with the ▲-key (example: 2200 minutes) and confirm with the o.K.-key. Rruunn ttiimmee and the hours for the watering time flash on the display. 6. Set the hours for the watering time with the ▲-key (example: 00 hours) and confirm with the o.K.-...
Page 15
15 gb 8. (b) select respective watering days with the ▲-key (example: ■ mo, ■ fr monday and friday) and confirm with the o.K.-key. Press ▲-key until the ■ over su disappears. The display returns to step 3 and the next highest program memory setting flashes. V if you would like to water your garden e...
Page 16
16 gb budget-function (% run-time) : the times of all stored watering programmes can be reduced cen- trally in intervals of 10 %, from 100 % down to 10 %, without having to change each interval programme. This is ideal if you wish to water your garden less in the autumn than in the summer. Note : if...
Page 17
17 gb 1. Press man. On / off-key to open the valve manually (or to close an open valve). Rruunn ttiimmee and the watering time in minutes (set to 3300 minutes in the works) flash for 5 seconds on the display. 2. Whilst the watering time in minutes is flashing, the watering duration can be modified w...
Page 18
18 gb the factory settings are restored. V press ▲-key and o.K.-key simultaneously for 2 seconds. All the lcd symbols are displayed for 2 seconds and the display moves to the normal display. • all the program data are set to zero. • the manual watering period is set to 00 ::3300 again. • the time an...
Page 19
19 gb 6. Automatic water distributor (optional) connecting the gardena automatic water distributor (art. No. 1198) allows you to control up to 6 watering lines with the water computer c 1060 profi / solar. Each of the 6 watering lines can only be actuated once a day. This is ideal where there is an ...
Page 20
20 gb the pre-programming takes into consideration the 30 minute break required between the programs as well as a minimum watering time of 30 seconds (display: 11 min.). This watering time is required to allow the automatic water distributor to switch to the next outlet and to ensure that the order ...
Page 21
21 gb by briefly opening the water flow the outlets on the automatic water distributor are switched further so that when the watering programs are reactivated (% run-time) the original order of the outlets for the required watering program is retained. When using the water computer c 1060 profi / so...
Page 22: 7. Cleaning
22 gb 7. Cleaning the filter should be checked regularly and cleaned when necessary. 1. Unscrew sleeve nut l of the water computer manually from the tap thread (do not use pliers). 2. Remove filter from sleeve nut l and clean. 3. Screw sleeve nut l of the water computer back on to the thread of the ...
Page 23
23 gb fault possible cause remedy rechargeable battery is flat. V place water computer in the sun for 1 - 2 days or charge the battery with a charger for 9 v block / nh 22 rechargeable batteries. Temperature on the display display appears after is higher than 60 °c. Temperature has dropped. V check ...
Page 24
24 gb fault possible cause remedy watering program is not program entry / modification v make program entry / being undertaken during or just before the modification outside the (no watering) start pulse. Programmed start times. Valve was opened manually v avoid possible program previously. Overlaps...
Page 25: 10. Accessories
25 gb 9. Putting your water computer out of operation only store the water computer with the battery charged. 1. Press menu-key 3 times, select prog. Off ■ (run-time 00 %) with the ▲-key and confirm with the o.K.-key. The watering programs are deleted. 2. Store water computer in a bright place which...
Page 26: 11. Technical Data
26 gb warranty 11. Technical data min. / max. Operating pressure : 0,5 bar / 12 bar minimum flow rate : 20 i / h flow medium : clear fresh water max. Medium temperature : 40 °c number of program-controlled watering cycles per day : up to 6 watering duration per program : 1 min. To 9 hours 59 min. Re...
Page 27
27 gb • the unit must have been handled properly and in keeping with the requirements of the operating instructions. • neither the purchaser or a non-authorised third party have attempted to repair the unit. Damage caused by frost is not covered by the warranty. This manufacturer’s guarantee does no...
Page 28
138 g product liability we expressly point out that, in accordance with the product liability law, we are not liable for any damage caused by our units if it is due to improper repair or if parts exchanged are not original gardena parts or parts approved by us, and, if the repairs were not carried o...
Page 29
139 r ∆κιαωµα υπατιτητας Κνουµε σαφς τι, σµφωνα µε τους νµους παραγωγς των προϊντων, δεν εµαστε υπεθυνοι για καµα ζηµι που προκλθηκε απ το προϊν µας εν δε χρησιµοποιθηκαν για λες τις συνδσεις αποκλειστικ και µνο τα γνσια εξαρτµατα ανταλλακτικ της gardena αν το σρβις δεν πραγµατοποιθηκε στο σρβις της...
Page 30
140 r Πιστοποιητικ συµφωνας ek Η υπογεγραµµνη, gardena manufacturing gmbh, hans-lorenser-str. 40, d-89079 ulm, πιστοποιε τι τα µηχαν- µατα που υποδεικνονται κτωθι, ταν φεγουν απ το εργοστσιο, εναι κατασκευασµνα σµφωνα µε τις οδηγες της Ευρωπαϊκς Κοιντητας και τα Κοινοτικ πρτυπα ασφαλεας και προδιαγρ...
Page 31
141 prog start time run time mo tu we th fr sa so 2 nd 3 rd 1 2 3 4 5 6 prog start time run time mo tu we th fr sa so 2 nd 3 rd 1 2 3 4 5 6.
Page 32
142 prog start time run time mo tu we th fr sa so 2 nd 3 rd 1 2 3 4 5 6 prog start time run time mo tu we th fr sa so 2 nd 3 rd 1 2 3 4 5 6.
Page 33
143 deutschland / germany gardena manufacturing gmbh service center hans-lorenser-straße 40 d-89079 ulm produktfragen: (+ 49) 731 490 - 123 reparaturen: (+ 49) 731 490 - 290 service@gardena.Com argentina argensem ® s.A. Calle colonia japonesa s / n (1625) loma verde escobar, buenos aires phone: (+ 5...
Page 34
144 italy gardena italia s.P.A. Via donizetti 22 20020 lainate (mi) phone: (+ 39) 02.93.94.79.1 info@gardenaitalia.It japan kakuichi co. Ltd. Sumitomo realty & development kojimachi bldg., 8f, 5 -1 nibanncyo, chiyoda-ku, tokyo 102-0084 m_ishihara@kaku-ichi.Co.Jp phone: (+ 81) 33 264 4721 luxembourg ...