Gardena classicCut special Operating Instructions Manual - 6. Trouble-Shooting
14
GB
L
3
I
H
I
Risk of injury !
Pulling the filament
out of the filament cassette :
1. Unplug the mains plug.
2. Turn over the Turbotrimmer and rest it on the rubber buffer
of the handle.
3. Release the cassette cover
F
by pressing both locking clips
G
and remove the cover.
4. Remove the filament cassette
H
.
5. Remove any dirt.
6. Pull approximately 5 cm of the filament
3
out of the new
filament cassette
H
through the eye of the plastic ring
I
.
7. Insert the filament cassette
H
in the filament cassette holder
J
so that the filament
3
is inside the metal case
K
.
8. Fit the cassette cover
F
on the filament cassette holder
J
so
that you hear both locking clips
G
click into place.
When replacing the cover, ensure that the filament is inside the
metal case and is not trapped.
v
If the cassette cover
F
cannot be touched down, turn the
filament cassette
H
to and fro, until the filament cassette
H
is completely in the filament cassette holder
J
.
6. Trouble-Shooting
Risk of injury from the cutting filament !
V
Always unplug the mains plug of the Turbotrimmer be-
fore troubleshooting.
You can pull the filament out of the filament cassette if the filament
is too short or if it is drawn inside the cassette.
1. Unplug the mains plug.
2. Remove the filament cassette as described under 5. Mainte-
nance
“Replacing the filament cassette” .
3. Press together the plastic ring
I
on the filament cassette
H
between your thumb and forefinger.
4. Draw the plastic ring
I
with the thumb of the other hand over
the side part of the filament cassette
H
(use a screwdriver
if necessary).
You can now access the filament that was drawn into the
filament cassette.
5. Unwind the filament
3
approximately 10 cm and thread
it through the eye of the plastic ring
I
. If neces-
sary, loosen the filament beforehand using
a screwdriver. The filament
3
may stand
out max. 2 cm over the knife
L
.
6. Pull the plastic ring
I
back over the
filament cassette
H
.
7. Reinstall the filament cassette as described
under 5. Maintenance
“Replacing the
filament cassette”.
F
H
3
J
K
I
G
G