Gardena Filter Set 3000 Operating Instructions Manual - page 3
11
G
10
G
3. Mode of Operation of the Filter
!
Water intake
Connection hose to the water feature pump in the pond.
"
Natural water treatment with GARDENA Zeolith
GARDENA Zeolith has a large surface area. The crystalline
micro-pores of the natural stone binds pollutants and filters
out dirt particles and impurities mechanically.
§
Water discharge
The purified water emerges through the perforated filter cover.
4. Putting into Operation
1. Screw the extension pipe
1
on to the pump.
2. Place
fountain attachment
2
on the extension pipe
1
.
1. Push the hose
3
from inside through the filter container
4
until the end of the hose
3
rests in the centre of the filter
container
4
.
2. Take the net of Zeolith
5
out of the protective plastic film
and insert in the filter container
4
.
3. Press the filter cover
6
in place around the filter container
4
until the filter cover
6
is heard to snap in position.
1. Push the hose
3
on to the side outlet of the pump.
2. Place filter and water feature pump in a stable position within
the garden pond so that the filter and the pump are completely
covered with water.
The fountain should project out of the pond.
3. Plug the mains plug of the pump into a 230 V AC power socket.
Warning : The water feature pump will start immediately !
Fit the pump :
Fit the filter :
Using the Flter Set
for the first time :
§
"
!
2
1
3
6
3
5
4
In Austria power cables should correspond to ÖVE-EM 42,
T 2 (2000) /1979 § 22 according to § 2022.1. According to this
standard pumps used in swimming pools and ponds should
only be operated via an isolating transformer.
v Please contact your electrician..
In Switzerland mobile appliances which are used outdoors,
must be connected via a residual-current device.
Before operating the pump, look to see if there is any damage
of the pump (esp. regarding power cable and plug). A damaged
pump must not be used. In case of damage, please have the
pump checked by our GARDENA Service Centre or by an
authorised electrician.
Data indicated on the type plate must match technical data of
the mains supply.
The pump must not be operated when there are people in the
water.
Swimming pools and garden ponds should be designed
according to international and national design regulations.
v Please consult a professional electrician.
Do not use the power cable to carry the pump or to pull the
plug out of the socket. Protect the power cable from heat, oil
and sharp edges.
Always unplug the equipment when dismantling the set, when
it is not in use and before maintenance.
v Always disconnect the pump from the mains before under-
taking any work on it.
v Please follow the safety and assembly instructions in these
operating instructions.
The temperature of the liquid used must not be below 4 °C or
above 35 °C.
Sand and other abrasive substances in the liquid cause in-
creased wear and reduce the output of the pump.
Place the filter in a stable position within the garden pond so
that the filter is completely covered by water.
For Austria
For Switzerland
Visual check
Check line voltage
Do not operate pump
when there are people
in the water
Swimming pools
and garden ponds
Do not use power cable
to carry the pump
Disconnect plug
Temperature of the liquid
used
Wear and reduced
output
Positioning the filter
www.devicemanuals.eu