Gardenline GCS-2000 User Manual - Operations Instructions
2.
An extension cord retainer is built into the switch handle that prevents
the extension cord from pulling out of the handle. To use this feature,
simply double the extension cord, about a foot from the end, and
insert it into the end of the handle. Hook the loop formed by doubling
the cords over the tab. Gently tug on the cord to ensure that it is firm-
ly retained in the saws handle. Plug the receptacle end of the extensi-
on cord into the tool’s power supply cord. (Fig. 7B)
3.
Grip the saw with both hands, left hand holding the front /handle (do
not hold chain brake) and the right hand holding the rear handle.
Thumbs and fingers should encircle both handles (Fig. 7C).
4.
With your Right thumb, push the Lock/Off button (C) forward at end
the top of the rear handle, and at the same time squeeze the trigger.
To stop the saw, release the trigger (Fig. 7D).
Note: It is not necessary to maintain pressure on the Lock/Off button once
the trigger is squeezed and the motor is running. The lock / off button is a
safety device to avoid accidental starting.
To stop the motor
The saw motor will automatically stop when the trigger is released. The
lock/ off button will have to be depressed and the trigger squeezed to res-
tart the motor.
Chain and bar lubrication
Adequate lubrication of the saw chain during cutting operations is essenti-
al to minimize friction with the guide bar. Your chain saw is equipped with
an automatic oiler system. The oiler automatically delivers the proper
amount of oil to the bar and chain. There is no flow adjustment. The oil
Fig.8
HELPLINE No. UK 0905-1460005
(£ 0,06/min)
• IRELAND 1520-932626
(E 0,15/min)
WEB SUPPORT: www.heltec.eu
Model Number: GCS-2000
23
Operations instructions
To start the saw
1.
Make sure the chain brake is disengaged whilst in a forward position.
The motor will not start if the chain brake is in the engaged position.
Disengage the chain brake by pulling backward toward the motor
(Fig. 7A).
Warning! Ensure the extension cord is of the proper size and
type for your saw (≥ 1,5 mm2)
HELPLINE No. UK 0905-1460005
(£ 0,06/min)
• IRELAND 1520-932626
(E 0,15/min)
WEB SUPPORT: www.heltec.eu
Model Number: GCS-2000
22
Operations instructions
5