Gardenline GPCS-42cc User Manual - page 3
3
SPARE PARTS LIST GPCS 42cc
NR. DESCRIPTION
NR. DESCRIPTION
NR. DESCRIPTION
14
GB
GB
1.
With a basic understanding of kickback, you can
reduce or eliminate the element of surprise. Sudden
surprise contributes to accidents.
2.
Keep a good firm grip on the saw with both hands,
the right hand on the rear handle, and the left hand
on the front handle, when the engine is running. Use
a firm grip with thumbs and fingers encircling the
chain saw handles. A firm grip will help you reduce
kickback and maintain control of the saw. Don’t let
go.
3.
Make sure that the area in which you are cutting is
free from obstructions. Do not let the nose of the
guide bar contact a log, branch, or any other
obstruction which could be hit while you are operat-
ing the saw.
4.
Cut at high engine speeds.
5.
Do not overreach or cut above shoulder height.
6.
Follow manufacturer’s sharpening and maintenance
instructions for the saw chain.
7.
Only use replacement bars and chains specified by
the manufacturer or the equivalent.
NOTE: Low-kickback saw chain is chain that has met the
kickback performance.
Your Gardenline Chain Saw is provided with a safety
label located on the chain brake lever/hand guard. This
label, along with the safety instructions on these pages,
should be carefully read before attempting to operate
this unit.
•
HOW TO READ SYMBOLS AND COLORS
(FIG. 1)
GREEN RECOMMENDED
Recommended cutting procedure.
WARNING
1. Beware of kick back.
2. Do not attempt to hold saw with one hand.
3. Avoid bar nose contact.
RECOMMENDED
4. Hold Saw properly with both hands.
•
DANGER! BEWARE OF KICKBACK!
KICKBACK may occur when the NOSE or TIP of the
guide bar touches an object, or when wood closes in
and pinches the saw chain in the cut.
Tip contact in some cases may cause a lightning-fast
reverse reaction, kicking the guide bar up and back
toward the operator.
PINCHING the saw chain along the BOTTOM of the
guide bar may PULL the saw forward away from the
operator. PINCHING the saw chain along the TOP of
the guide bar may PUSH the guide bar rapidly back
toward the operator.
Any of these reactions may cause you to lose control of
the saw, which could result in serious personal injury.
IMPORTANT SAFETY
WARNING: RED Used to warn that an
unsafe procedure should not be performed.
1
2
3
4
Fig. 1
WARNING: Kickback can lead to dangerous
loss of control of the chain saw and result in
serious or fatal injury to the saw operator or to
anyone standing close by. Always be alert.
Rotational kickback and pinch-kickback are
major chain saw operational dangers and the
leading cause of most accidents.
Fig. 2A
A
A
B
A
A
B
C
Fig. 2B
BEWARE OF:
ROTATIONAL KICK-
BACK (Fig. 2A)
A = Kickback path
B = Kickback reaction
zone
THE PUSH (PINCH
KICKBACK) AND PULL
REACTIONS (Fig. 2B)
A = Pull
B = Solid objects
C = Push
We declare under our sole responsibility that this product is in conformity with the following standards or
standardized documents:
EN ISO 11681-1:2004
in accordance with the regulations:
98/37EEC, 89/336/EEC, 2000/14/EC
from 01-09-2005
ZWOLLE NL
W. Kamphof
Quality department
It is our policy to continuously improve our products and we therefore reserve the right to change the product
specification without prior notice.
Servotool B.V • Lingenstraat 6 • 8028 PM Zwolle • The Netherlands
CE
DECLARATION OF CONFORMITY (UK)
1
CAP, BEARING
2
BEARING
3
CRANK/ROD ASS'Y
4
PISTON
5
RING, PISTON
6
ROLLER, PISTON
7
PIN, PISTON
8
RING
9
CASE, CRANK
10
SPARK PLUG
11
CYLINDER
12
RUBBER, ISOLATOR
13
SPACER
14
SCREW
15
ISOLATOR, CARBURETOR
16
SPRING WASHER
17
SCREW
18
SPACER
19
CARBURETOR
20
AIR FILTER ASS/Y
21
NUT
22
SCREW
23
HANDLE, LEFT, 348C GREEN
24
TRIGGER, THROTTLE, 122C YELLOW
25
THROTTLE LATCH, RELEASE, 122C YELLOW
26
SPRING
27
SCREW
28
RUBBER
29
HANDLE, RIGHT, 348C GREEN
30
SWITCH
31
WASHER
32
SCREW
33
HANDLE, FRONT, BLACK
34
STARTER ASS'Y, BLACK+122C YELLOW
35
NUT
36
FLYWHEEL
37
SCREW
38
WIRE ASS'Y
39
IGNITION ASS'Y
40
CONDUCTIVE PLATE
41
OIL CAP ASS'Y, BLACK
42
SPRING ASS'Y
43
PRIMER
44
FUEL CAP ASS'Y, BLACK
45
SPRING
46
SCREW
47
FILTER
48
HOUSING ASS'Y, 348C GREEN
49
HOLDER, CABLE
50
LEVER, CHOKE, 122C YELLOW
51
HOLDER, CHOKE LEVEL
52
SPRING
53
CONNECTOR
54
OIL PIPE
55
PUMP ASS'Y
56
SPACER
57
BAFFLE
58
BAFFLE
59
MUFFLER ASS'Y
60
SCREW
61
CABLE, THROTTLE
62
FUEL PIPE
63
WOODRUFF KEY
64
MESH
65
FILTER, AIR
66
SPIKED BUMPER
67
SCREW
68
SCREW
69
SHROUD, 348C GREEN
70
SCREW
71
NUT
72
FELT
73
WORM
74
CAP, ANTI-DUST
75
SCREW
76
SCREW
77
DRUM ASS'Y
78
CLUTCH ASS'Y
79
CAP, ANTI-DUST
80
NUT
81
BRAKE KIT ASS'Y, BLACK
82
NUT
83
18" BAR, OREGON
84
CHAIN, OREGON 91PJ
85
WASHER
86
SCREW
87
WRENCH
88
BAR SHEATH, 18"