- DL manuals
- Gardenline
- Lawn and Garden Equipment
- MFH3300-4P
- Instruction Manual
Gardenline MFH3300-4P Instruction Manual
Summary of MFH3300-4P
Page 1
N16188 made in china petrol multi garden tool instruction manual after sales support mfh3300-4p tel: 1300 855 831 web: www.Scheppach.Com.Au.
Page 2: Petrol Multi Garden Tool 1
Petrol multi garden tool 1 what your 1 year warranty means great care has gone into the manufacture of this product and it should therefore provide you with years of good service when used properly. In the event of product failure within its intended use over the c 1 years after the date of purchase...
Page 3
Index: i. Pictures page 3 ii. Explanation of the symbols on the equipment page 8 iii. Introduction page 9 iv. Device description page 9 v. Scope of delivery page 9 vi. Safety instructions page 10 vii. Remaining hazards page 11 viii. Intended use page 12 ix. Technical data page 12 x. Before starting ...
Page 4
2 3 2 3 1 2 3 4 4 a b c d 5 6 7 23 19 20 21 22 24 1 9 6 5 4 3 1 2 7 8 11 10 12 13 14 15 16 17 18 25 after sales support tel: 1300 855 831 web: www.Scheppach.Com.Au after sales support tel: 1300 855 831 web: www.Scheppach.Com.Au 26 27 28.
Page 5
4 8 13 11 12 17 17b 17a 10 17a 14 15 17 16 k l 9 after sales support tel: 1300 855 831 web: www.Scheppach.Com.Au.
Page 6
4 5 18 a 20 21 19 23 22 8 11 7 24 25 27 26 b after sales support tel: 1300 855 831 web: www.Scheppach.Com.Au after sales support tel: 1300 855 831 web: www.Scheppach.Com.Au.
Page 7
35 32 33 34 30 31 wind cord 28 29 36 37 6 after sales support tel: 1300 855 831 web: www.Scheppach.Com.Au.
Page 8
38 39 7 6 after sales support tel: 1300 855 831 web: www.Scheppach.Com.Au after sales support tel: 1300 855 831 web: www.Scheppach.Com.Au.
Page 9
8 ii. Explanation of the symbols on the equipment aus read the instruction manual. Aus warning! Denotes risk of personal injury, loss of life, or damage to the tool in case of non-observance. Aus warning! The exhaust and other parts of the engine will get very hot during use, do not touch! Aus warni...
Page 10
8 iv. Device description (fig. 1) 1. Motor drive unit 2. Pole saw 3. Hedge trimmer 4. Power scythe 5. Grass trimmer 6. Front handle 7. Stop switch 8. Throttle lever “lock” 9. Starter cable 10. Tank 11. Throttle lever 12. Automatic oil pump 13. Saw chain 14. Chain saw blade 15. Cutting unit 16. Adjus...
Page 11
Vapor can escape. – make sure the handles are dry, clean, and free of petrol mixed with oil. – do not use the tool without exhaust pipe and when the exhaust pipe guard is not properly installed. – do not touch the exhaust pipe, there is a risk of burns. – only use the fuel recommended in the manual....
Page 12
10 • pay particular attention to branches under tension. • always pull the tool out of the wood when the saw chain is running. • never work with the tool above shoulder height or with only one hand. • always stand away from the falling direction. Posi- tion yourself on a slope above the tree to be f...
Page 13
Weight brush cutterr kg 7.2 weight pole saw kg 7.1 weight hedge trimmer kg 7.7 subject to technical changes! Information concerning noise emission measured ac- cording to relevant standards: sound pressure l pa = 94 db(a) sound power l wa = 114 db(a) uncertainty k pa = 3 db(a) wear ear-muffs. The im...
Page 14
12 take the outer flange off after release the nut, then put the blade (17), outer flange (17b), shield (17a) and nut according to priority as below picture. Note the blade rotation direction needs be same as below picture. Use screw driver to hold flange and tighten nut counter-clockwise, ensure th...
Page 15
• unscrew the tank cap (b) and remove it. Fig. 19 • pour in the fuel carefully. Avoid spilling! • screw the tank cap on firmly by hand. Draining fuel. Fig. 36 • hold a collection container beneath the fuel drain bolt. • unscrew the tank cap and remove it. • allow the fuel to run out completely. • sc...
Page 16
14 to minimize the risk of accidents by use of the cutting blade, take note of following points: • never cut shrubbery or wood whose diameter is larger than 2cm. • avoid contact with metal bodies, stones, etc. • periodically check the cutting blade for damages. Nev- er continue to use a damaged cutt...
Page 17
Plies to non-authorised modifications of the tool, use of non-authorised spare parts, accessories, working tools, unrelated and not intended use, secondary damages due to use of faulty components. Wear parts even when used in the intended way, some components are subject to normal wear. They have to...
Page 18
16 parts they are in the shape and size of the original parts as necessary. • sharpening a chain should be performed only by ex- perienced users! Notice. Below the angle and dimensions if the chain is not properly sharpened or the depth is too small, there is a higher risk of reversion effects and r...
Page 19
5 fill the tank with the relevant mixture of fuel and oil. See the section „fuel and oil“. Transport to transport the machine, empty the petrol tank as described in section 8 draining fuel. Clean coarse dirt off the equipment with a brush or hand brush. Xv. Disposal and recycling the equipment is su...
Page 20
18 19 xvi. Troubleshooting the table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equip- ment fails to work properly. If the problem still persists after working through the list, please contact your nearest ser- vice workshop. Important hint in ...
Page 21: Warranty Details
Warranty details after sales support telephone: 1300 855 831 internet: www.Scheppach.Com.Au petrol multi garden tool the product is guaranteed to be free from defects in workmanship and parts for a period of 12 months from the date of purchase. Defects that occur within this warranty period, under n...
Page 22: Warranty Details
Warranty details after sales support telephone: 1300 855 831 internet: www.Scheppach.Com.Au petrol multi garden tool the product is guaranteed to be free from defects in workmanship and parts for a period of 12 months from the date of purchase. Defects that occur within this warranty period, under n...