Gardner Denver C2500Q QUINTUPLEX Operating And Service Manual - page 5
Page iv
INDEX
Crankshaft Assembly .................................. 25
Crankshaft Replacement ............................ 26
Crosshead Assembly ….............................. 23
Crosshead Guide and Stay Rods …............ 24
Daily Routine Maintenance Schedule.......... 18
DANGER NOTICES, SECTION 1................. 1
Covers and Guards............................... 2
Equipment Moving and Lifting............... 2
Flammable, Hot, Cold or Corrosive
Fluid Pumping............................... 5
Hammer Lug Fasteners……………….. . 1
High Pressure Liquid Jetting,
Blasting and Cleaning ................... 6
Pressurized Pump Systems .................. 3
Valve Seat Pulling ................................ 2
DESIGN DESCRIPTION AND
SPECIFICATIONS, SECTION 2 ........... 9
Fluid End Description.................................. 12
Fluid End Removal and Installation ............ 20
Fluid End Service ....................................... 20
Foreword …………………………………..…. ..ii
Gear Reduction Unit ...............................10,25
General Requirements and Safety Rules .... 20
Introduction................................................... 9
Lube Pump Suction Piping Sizing and
Requirements ..................................... 15
Lube System Pump .................................... 15
Lubrication, Plunger / Packing .................... 16
Monthly Routine Maintenance Schedule ..... 18
Oil Stop Head Seal Retainer and
Gear Covers .................................. 23
Ordering Instructions, Repair Parts ................ i
Periodic Routine Maintenance Schedule........ 17
Plunger / Packing Lubrication ........................ 16
Plunger Packing Lubrication Recommendation
Chart ....................................................... 19
Plungers and Packing Replacement .............. 21
Plunger Size Change..................................... 22
Power End.................................................10,23
Power End and Gear Reduction
Unit Lube System .................................... 11
Power End Lubrication System ...................... 15
Preparation after Shipping and Storage ......... 14
PREPARATION, OPERATION AND
MAINTENANCE, SECTION 3.................. 14
Pump Design................................................. 10
Pump Mounting Instructions........................... 14
Quarterly Routine Maintenance Schedule ...... 18
Rebuilding Data ............................................. 33
REBUILDING DATA, RECOMMENDED
RUNNING CLEARANCES AND
TORQUES, SECTION 6.......................... 33
Recommended Running Clearances – Actual 33
Repair Parts, Ordering Instructions ................... i
SERVICE PROCEDURES, SECTION 4 ........ 20
Startup and New Pump Run-In Procedure ..... 16
Torques ......................................................... 34
TROUBLE-SHOOTING, SECTION 5............. 27
Warranty ................................................ …….35
Valve and Seat Replacement ........................ 22