1. DL manuals
  2. Garland
  3. Griddle
  4. ECG
  5. Installation And Operating Instruction

Garland ECG Installation And Operating Instruction

Manual is about: ECG SERIES ELECTRIC CHAIN GRIDDLES

Summary of ECG

  • Page 1

    P/n: 3073400 04/2001 installation and operating instructions for ecg series electric chain griddles this manual should be handed to the equipment owner and retained for future reference. The following instructions should be read carefully as the manufacturer cannot be held responsible for any damage...

  • Page 2: General Information

    1 general information 1. Damage check: check carton or crate for possible damages incurred in shipping. After carefully examining, check for “concealed” damage. Report any damage immediately to your carrier. 2. Any protective material covering stainless steel parts must be removed. 3. All units are ...

  • Page 3: Technical Specifications

    2 do not operate the product unless all service and access panels are in place and fastened properly. Do not attempt to repair or replace any part of this product unless all main power supplies have been disconnected. Warning - to avoid personal injury: use extreme caution in setting up, operating a...

  • Page 4: General Installation

    3 note: a means of disconnection from the supply having a contact separation of at least 3 mm in all poles must be incorporated in the fixed wiring. Warning: this appliance must be grounded general installation a qualified person as required by the local electrical authorities must install this equi...

  • Page 5: Installation Procedure

    4 combustible wall minimum clearance non-combustible wall minimum clearance all models mm ins mm ins sides 152 6 152 6 back 152 6 152 6 installation procedure general 1. Carefully remove the unit from the crate. All packing material must be removed from the unit. The protective material covering the...

  • Page 6: Maintenance & Cleaning

    5 sticking of product. Never salt food over griddle since this will build up a gummy residue making it difficult to clean. Avoid hitting the surface of the griddle with the edge of a spatula since this will cause nicks. The most frequently used temperatures are 149 •c to 182•c (300•f to 360•f). Afte...

  • Page 7

    6 to prevent scratching. Wash a small area at a time and rinse the washed area with a clean sponge dipped into a disinfectant and wipe dry with a soft clean cloth before it can dry. Use only stainless steel, wood or plastic tools to scrape off heavy deposits of grease or oil. Do not use ordinary ste...

  • Page 8

    7 3. Remove the grease drawer, empty and wash thoroughly with soap & water. Replace. Cleaning instructions (for heavy build up) (after using cleaners & grease cutter, re-season the griddle) apply to a warm griddle for best results. 1. Using a traditional 64mm-76mm (2 ½”-3”) scraper or spatula scrape...

  • Page 9: Servicing

    8 3. Do not use the griddle as a hot top. A large pan or pot will trap heat and can cause the griddle plate to warp. 4. Do not overheat the griddle to preheat faster. Preheating only takes 15-20 minutes. Servicing to ensure efficient and safe operation of the appliance it is recommended that servici...

  • Page 10

    9.

  • Page 11

    10

  • Page 12

    11 continuous improvement is a garland policy; therefore specifications are subject to change without notice. Manufactured by: distributed by: garland commercial ranges limited garland commercial industried, inc. 1177 kamato road, mississauga, 185 east south street, ontario, canada l4w 1x4 freeland,...