Garland HEEGM24CE Installation And Operation Manual - Pre-Installation
Part # 4532435 Rev 02 (Sep 9/14)
Page 5
Standard Features
•
All stainless steel construction.
•
Front rail with cut outs to hold 1/3 size food pans (pans not included).
•
Heavy duty reversible cast iron grates with wide edge on one side and fi ne edge on the other. Included: brush and
scraper combination tool for cleaning grates.
•
Two grate positions to choose from: the standard position, with a slight 2° slope to the front or the second position, with
a 10° slope to the front and more distance between the product and the burner.
•
Large capacity, removable grease tray(s). HEEGM24CE & 36CE models have one tray and HEEGM48CE & 60CE have two
trays.
• Energy
effi
cient cast iron burners.
•
Complete system ON/OFF power switch(es), which ignites burners and shuts them down. HEEGM24CE & 36CE models
have one switch and HEEGM48CE & 60CE have two switches.
• Complete
fl ame failure protection.
•
Each burner outputs 14,500 BTU for natural gas & 13,000 BTU for propane gas, and is individually controlled by a manual
high-low valve. Reference the "CE Approved Gas Category" table for applicable gas category, gas type and supply
pressure.
•
24" and 36" units are direct spark to the main burner. 48" and 60" units are direct spark to a pilot which then lights a pair
of main burners.
•
10-foot (3 meters) power cord with no plug head.
•
¾” (19.1mm) gas regulator for applicable gas type, and NPT to ISO adapter supplied with all units.
Optional Features
•
2-1/8" solid stub front rail, in lieu of standard 1/3 pan rail N/C
•
Fajita pan grate designed specifi cally for holding/warming fajita pans, in lieu of two reversible or single sided grates N/C.
•
Equipment Stands are available, see HEMST specifi cation sheet.
•
10-foot (3 meters) power cord with CEE7/7 plug head or BS1363/A plug head.
Standard and Optional Features
PRE-INSTALLATION
INSTALLATION, MAINTENANCE AND REPAIRS SHOULD BE
DONE BY AN AUTHORIZED SERVICE AGENCY. FOR A LIST OF
AUTHORIZED SERVICE AGENTS, REFER TO THE MANITOWOC
WEBSITE AT www.ManitowocFoodservice.com
Introduction
Garland manufactures the HEEGM series broilers in several
sizes. While service and customer operation may vary
from size to size, installation is similar for each. All units are
shipped fully assembled, except for the radiants and top
grates, which are packaged in separate boxes. Each unit
is tested, adjusted and inspected at the factory prior to
shipment.
Damage Check
After unpacking the unit, carefully inspect the unit for
visible and concealed damage. Report any damage
immediately to your carrier to fi le the appropriate freight
claims.
Rating Plate
The rating plate can be found on the inside face of the left
leg. If necessary, remove the grease drawer to read the
information. If service or replacement parts are needed,
refer to the FULL model number (prefi x, suffi
x, letters and
numbers) AND serial number on the rating plate when
contacting the factory or authorized service agency. These
numbers ensure proper unit identifi cation and aid in
providing faster and accurate service.
The rating plate contains other important information
critical to the proper installation of the unit. It specifi es the
gas type; gas pressure; voltage and clearance requirements
for the appliance.