Garland MO DU 10000-360 Installation, Operation And Maintenance Manual - 4.7

Installation  

RTCSmp 

Built-In Module-Line Dual/Quad Cooktops 

Part Number 4532415 12/14 

Page 35 

4.7 

Electrical Installation 

All electrical connections must be carried out by a 

certified electrical contractor, who is responsible for the 

correct rating and installation of the induction unit. The 

contractor has to comply with all legal safety 

regulations. 

IMPORTANT 

  This appliance component requires additional features and components to comply with appliance and 

electrical standards.  It is the responsibility of the customer and installer to interpret and comply with all 

applicable safety and electrical standards. Refer to details in section 4.1 Important Safety and Electrical 

Requirements. 

  Refer to the electrical specifications in chapter 3 Dimensions and Technical Specifications  AND the 

rating plate/instruction labels on the unit. Always refer to the rating plate/instruction labels on the 

unit to verify the electrical data. The rating plate/label information overrides the information listed in this 

manual. 

  Ensure the supply voltage and the line current match the specifications given on the rating plate. A 

stable mains supply must be provided. 

CAUTION 

Wrong voltage will damage the induction unit. Follow 

strictly the specifications on the rating plate. 

  The electrical installation must satisfy the national and local electrical codes. 

  If ground fault current protective switches are used, they must be provided with selective activation and 

designed for a minimum fault current of 30mA. Multiple generators with a mains connection must not be 

connected to a single fault current protective switch. 

  The electrician must equip the generator with a mains cable in accordance with the applicable 

regulations. Ensure the mains cable connection is absolutely correct. 

  The electrician must ensure the induction unit can always be disconnected from the power supply by a 

switch, in accordance with the applicable regulations. 

  All cables must be routed / protected and tension free.  

  Always route sensor and communication cables separately and away from the coil cables.  

  To manage electromagnetic interference, excess cable length can be dressed and tied in a 

serpentine or S pattern, NOT coiled.  

Put the control knob in the 0 (OFF) position BEFORE connecting the unit to the electrical supply.