Garmin 3000 Series Installation Instructions Manual - page 2
GPSMAP 3000 Series Installation Instructions
To install the bail-mount bracket
➊
:
1. Usingthebailmountasatemplate,markthelocationofthefourmountingholes.Besuretoleaveatleast2in.(5.1cm)ofclearancebehind
theGPSMAP3000serieschartplotterforthewiring.
NotE: Mount a GPSMAP 3005C/3205C chartplotter 10 in. (25 cm), a GPSMAP 3006/3206C chartplotter 12 in. (30 cm), and a
GPSMAP 3010C/3210C chartplotter 24 in. (60 cm) from a magnetic compass to avoid interference.
2. Usinganappropriatelysizeddrillbit,drillthepilotholesforyourmountinghardware.
3. Securethebailmounttothesurfacewithyourmountinghardware.
To install the GPSMAP 3000 series chartplotter on the bail-mount bracket
➋
:
1. LooselyattachthemountingknobstotheGPSMAP3000serieschartplotter.
2. Slidethechartplotterontothebailmount,andtightenthemountingknobs.
➊
RANGE
PAGE
QUIT
FCTN
FIND
ENTER
MARK
DATA
CNFG
ADJ
MENU
NAV
MOB
ABC
DEF
JKL
GHI
MNO
TUV
PQRS
WXYZ
1
2
3
4
5
6
7
8
9
0
-
+
Bail mount
Mounting knobs
➋
Flush Mounting the GPSMAP 3000 Series Chartplotter
Use the included flush-mount template and hardware to flush mount your GPSMAP 3000 series chartplotter.
NotE: Make sure the surface on which you mount the chartplotter has at least 2 in. (5.1 cm) of open space behind it to fit the chartplotter and the
connected wires.
NotE: Mount a GPSMAP 3005C/3205C chartplotter 10 in. (25 cm), a GPSMAP 3006/3206C chartplotter 12 in. (30 cm), and a
GPSMAP 3010C/3210C chartplotter 24 in. (60 cm) from a magnetic compass to avoid interference.
Hardware (included):
• Flush-mounttemplate
• Fourthreadedmountingstuds
• Fourflatwashers
• Eighthexnuts
Tools required (not included):
• Jigsaw
• Maskingtape
• Scissors
• Drill
• Drillbits—
1
/
8
"(3mm)and
3
/
8
"(6mm)
•
1
/
16
in.(2mm)Allen(Hex)wrench
• 4mmsocketorwrench
• Marker
• Centerpunchandhammer
To flush mount a GPSMAP 3000 series chartplotter:
1. Theflush-mounttemplateisincludedintheproductbox.Trimthetemplateandensureitwillfitinthelocationatwhichyouwanttoflush
mountthechartplotter.
2. Trimtheflush-mounttemplateandtapeittothelocationatwhichyouwanttomountthechartplotter.
3. Usinga
3
/
8
in.(10mm)drillbit,drilloneormoreofthefourpilotholesinsidethecornerofthetemplatetobegincuttingthemountingsurface.