Garmin GHP 10V Marine Autopilot System Installation Instructions Manual
GHP 10V Installation Instructions
1
GHP
™
10V Installation Instructions
To obtain the best possible performance and to avoid damage to your
boat, install the Garmin
®
GHP 10V marine autopilot system according
to the following instructions. Professional installation of the autopilot
system is highly recommended.
The GHP 10V is compatible with C3 or newer Volvo
®
EVC systems.
Contact Volvo for more information on updating older EVC systems.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation, contact
Garmin Product Support.
NOTE: There is an installation checklist on the last page of these
instructions. Remove the last page and refer to the checklist as you
proceed through the GHP 10V installation.
Registering Your Device
Help us better support you by completing our online registration today.
• Go to
• Keep the original sales receipt, or a photocopy, in a safe place.
For future reference, write the serial number assigned to each
component of your GHP 10V system in the spaces provided on
.
The serial numbers are located on a sticker on each component.
Contacting Garmin
Contact Garmin Product Support if you have any questions while using
your GHP 10V.
, or contact Garmin USA
by phone at (913) 397.8200 or (800) 800.1020.
In the UK, contact Garmin (Europe) Ltd. by phone at 0808 2380000.
In Europe, go to
and click Contact Support
for in-country support information, or contact Garmin (Europe) Ltd. by
phone at +44 (0) 870.8501241.
Important Safety Information
WaRnInGS
You are responsible for the safe and prudent operation of your
vessel. The GHP 10V is a tool that will enhance your capability to
operate your boat. It does not relieve you from the responsibility of
safely operating your boat. Avoid navigational hazards and never leave
the helm unattended.
Always be prepared to promptly regain manual control of your boat.
Learn to operate the GHP 10V on calm and hazard-free open water.
Use caution when operating the GHP 10V near hazards in the water,
such as docks, pilings, and other boats.
See the Important Safety and Product Information guide in the product
box for product warnings and other important information.
CautIon
Equipment to be connected to this product should have a fire enclosure
or be provided with a fire enclosure.
Always wear safety goggles, ear protection, and a dust mask when
drilling, cutting, or sanding.
Notice
When drilling or cutting, always check the opposite side of the surface.
Be aware of fuel tanks, electrical cables, and hydraulic hoses.