Garmin GTN 6 series Maintenance Manual - page 85
Manual is about: Part 23 AML STC
of
160
190-01007-A1
System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
Rev. 6
Page 6-17
Figure 6-8. TVS/Fuse Replacement (TVS1/F1)
TVS2 Removal
1. Remove the ring terminal from ground as shown in Figure 6-10.
2. Carefully remove heat shrink from the TVS assembly, ensuring not to cut the insulation on the
wire under the heat shrink.
3. If replacing the entire TVS assembly, unplug the 4-pin connectorand proceed to step (1) of the
replacement. If it is not necessary to replace all of the TVSs, carefully unpin the failed TVS(s).
4. Apply heat with a soldering iron to opposite end of the TVS assembly so that the bad TVSs can be
removed. Use caution when applying heat to the solder joint to ensure that the remaining TVSs
aren’t damaged.