Garmin GTX 330 Mode S Pilot's Operating Handbook And Faa Approved Airplane Flight Manual

Summary of GTX 330 Mode S

  • Page 1

    P/n 11934-s28 1 of 8 cirrus design section 9 sr20 supplements pilot’s operating handbook and faa approved airplane flight manual supplement for garmin gtx 330 mode s transponder when a garmin gtx 330 transponder is installed in the cirrus design sr20, this supplement is applicable and must be insert...

  • Page 2: Figure - 1

    2 of 8 p/n 11934-s28 section 9 cirrus design supplements sr20 figure - 1 gtx 330 garmin s t b y o f f on ident vfr 0 1 2 3 4 5 6 7 8 9 clr func start stop crsr alt 1 2 3 4 5 6 7 8 9 10 1. Identification key 2. Mode selector keys a. Off b. Stby (standby) c. On d. Alt 3. Display window 4. Func (functi...

  • Page 3: Section 1 - General

    P/n 11934-s28 3 of 8 cirrus design section 9 sr20 supplements section 1 - general the airplane is equipped with a single garmin gtx 330 atc mode s transponder with ident capability. This supplement provides complete operating instructions for the gtx 330 and does not require any additional data be c...

  • Page 4: After Landing

    4 of 8 p/n 11934-s28 section 9 cirrus design supplements sr20 after landing 1. Transponder mode selector keys ............................. Stby or off if the transponder is in the alt or on mode for landing, and the airplane is in a mode s environment, the transponder will automatically switch to g...

  • Page 5: Reply Light

    P/n 11934-s28 5 of 8 cirrus design section 9 sr20 supplements while providing the usual identification code and pressure altitude information as mode a and c transponders, the mode s transponder also uses a unique aircraft address to enhance the tracking capabilities of atc and other mode s transpon...

  • Page 6: Code Selector Keys

    6 of 8 p/n 11934-s28 section 9 cirrus design supplements sr20 reply to any interrogations from an atc secondary ground surveillance radar system. This is the normal position for ground operations in the sr20. • note • depend on the atc environment, stby or gnd mode is automatically entered from alt ...

  • Page 7: Important Codes

    P/n 11934-s28 7 of 8 cirrus design section 9 sr20 supplements crsr key during code entry will remove the cursor and cancel the entry. • note • when making routine code changes, avoid inadvertent selection of code 7500 and all codes within the 7600 series (7600 – 7677) and 7700 series (7700 – 7777). ...

  • Page 8: Function Display

    8 of 8 p/n 11934-s28 section 9 cirrus design supplements sr20 flight time, count up timer, count down timer, contrast, and display brightness. Start/stop key - starts and stops the altitude monitor, count up, count down, and flight timers. In configuration mode, steps through functions in reverse. C...