Garmin GTX 35R Installation Manual - page 32
190-01499-10
GTX 35R/45R Installation Manual (Non-Certified Aircraft)
Rev. 1
Page 4-2
4.2
Backshell Assembly Parts
The GTX 35R/45R connector kits include backshell assemblies and ground adapter assemblies. Use the
shield block ground kit to terminate shield grounds to the backshell housing. Garmin part numbers for the
D-sub connectors and the backshell assemblies are in table 4-1.
Table 4-1 Backshell Assembly
Refer to
Figure 4-2
Description
Garmin P/N
Notes
1
Backshell (P3251)
Backshell (P3252)
125-00084-00
125-00081-00
[1]
2
Shield block (P3251)
Shield block (P3252)
117-00147-01
117-00147-00
[2]
3
Screw, 4-40 x.250, FLHP100
, SS/P, nylon
211-63234-08
[2]
6
Screw, 4-40x.375, PHP, SS/P, with nylon
211-60234-10
[1]
7
Strain relief (P3251)
Strain relief (P3252)
115-00499-03
115-00499-00
[1]
8
Cover (P3251)
Cover (P3252)
115-00500-03
115-00500-00
[1]
9
Screw, 4-40x.187, FLHP100, SS/P, with nylon
211-63234-06
[1]
10
Connector, D-sub, HD, 62-pin (P3251)
Connector, D-sub, HD, 15-pin (P3252)
330-00185-62
330-00185-15
[3]
11
Multiple conductor shielded cable
As necessary
[4]
12
Shield terminator
As necessary
[4] [5]
13
Wire, insulated, 20-22 AWG (3 inches maximum length) As necessary
[4] [5]
14
Pin contacts, #22D
336-00021-00
[3]
15
Ring terminal, #8, insulated, 18-22 AWG, 14-16 AWG
MS25036-149,
MS25036-153,
MS25036-156
[4] [6]
16
Screw, PHP, 8-32 x .312", stainless or cad plated steel
MS51957-42,
MS35206-242
[4] [6]
17
Split washer, #8, (.045" compressed thickness) stainless
or cad-plated steel
MS35338-137,
MS35338-42
[4] [6]
18
Flat washer, #8, .032" thick, .174" ID, .375" OD,
stainless or cad plated steel
NAS1149CN832R,
NAS1149FN832P
[4] [6]
19
Silicone fusion tape
249-00114-00
[4]