Garmin StreetPilot 2730 Set Up And Go
➍
Configure your StreetPilot 2730.
Flip the power switch down to turn on your 2730. Follow the screen prompts to set up the 2730:
➋
Touch a time zone. Touch
Next
.
➌
Select an option. Touch
Next
.
➊
Touch a language. Touch
Next
.
➍
Select an option. Touch
Next
.
➏
Touch
Done
.
➎
Wait a few minutes.
Finding a Destination
➋
Touch
Food, Hotel…
.
➌
Touch
and
Recreation
.
➊
Touch
Where To?
➍
Touch a category.
➏
Touch
Go To
.
➎
Touch a place.
Following Your Route
Follow the route to your destination using the map. As you travel, your
2730 guides you to your destination with voice prompts, arrows, and
directions along the top of the map. If you depart from the original route,
your 2730 recalculates the route and provides new route instructions.
StreetPilot
®
2730
set up and go!
WARNING:
For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the 2730 installed to place and secure the device so it will
not interfere with the vehicle operating controls and safety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of an
accident.
Getting Your StreetPilot 2730 Ready
To use the mounting base with adhesive disks, start with
➊
. To use the non-skid friction mount, start with
➋
.
➊
Attach the mounting base to your dashboard.
1. Clean and dry the area where you want to place the mounting base.
2. Remove the liner from the bottom of the mounting disk.
3. With the locking lever facing you, position the base on the cleaned area.
Apply pressure to adhere the base to the dashboard.
➋
Mount your StreetPilot 2730 to the base.
1. Align the power plug on the vehicle adapter to the connector and slide the
plug into the connector until fully seated.
2. Slide the locking lever on the base to the left (unlocked).
3. Slide the bottom of the 2730 into the base until it clicks into place.
4. Slide the locking lever to the right (locked).
5. Plug the power adapter into a 12-Volt receptacle in your vehicle.
6. Route the cable so it does not interfere with vehicle operation.
➌
Connect the GXM 30 XM Smart Antenna.
Plug the USB cable from the GXM 30 into the USB connector on the back of the
2730 (under the weather cap). For more information, see the GXM 30 XM Smart Antenna Owner’s Manual.
© Copyright 2005–2006 Garmin Ltd. or its subsidiaries
March 2006
190-00476-01 Rev. B
Printed in Taiwan
Your route is marked with a magenta line.
Follow the arrows.
A checkered
flag marks your
destination.
locking lever
release tab
power
plug
mounting
base