Due to the restricted space around the carburetor and intake manifold the honda 8/9.9 throttle actuator runs the throttle only from idle to two thirds full. Though you do not get auto control to full throttle, you do get very fine control in the normal trolling range. You will need to keep the manua...
Use the #10 screw provided with the actuator to replace the screw you just removed and attach the throttle actuator assembly (item 1) as shown. Keep both washers on the screw head side of the air horn. Apply a little thread lock to the screw and tighten it. Near the left end of the carburetor there ...
Loosen the little screw on the carburetor bell crank lever a few turns. With the carburetor at idle position and the shaft of the throttle actuator motor fully extended toward the carburetor, pull the string (120 lb. Test spetra fishing line) through the hole in carburetor bell crank lever till it i...
