Usb data card programmer user’s manual and installation guide.
© 2000 garmin corporation garmin international, inc. 1200 e 151 st street, olathe, kansas 66062 u.S.A. Tel. 913/397.8200 or 800/800.1020 fax. 913/397.8282 garmin (europe) ltd. Unit 5, the quadrangle, abbey park industrial estate, romsey, so51 9aq u.K. Tel. 44/1794.519944 fax.44/1794.519222 garmin (a...
I introduction introduction thank you for choosing the garmin usb data card program- mer. To get successful results from your new programmer, take time to read through this user’s manual in order to fully understand all of the operating procedures. This manual is organized into three sections: the i...
Ii introduction software license agreement this software is owned by garmin corporation (“garmin”) and is protected under copyright laws and international copyright treaties. This software is licensed, not sold. This software is provided under the following license which defines what you may do with...
Iii introduction software license agreement 4. Term: this license shall continue for as long as you use the product. However, this license will terminate automatically without notice from garmin if you fail to comply with any of its terms or conditions. You must agree, upon terminations, to destroy ...
Iv introduction features 6 ft. Usb data cable data card slot (accepts only garmin data cards) data card programmer usb connector garmin data cards the usb data card programmer utilizes garmin data cards. Available in five sizes: 8 mb data card 16 mb data card 32 mb data card 64 mb data card 128 mb d...
1 introduction installation of the usb data card programmer and device drivers 1. Connect the usb connector on the end of the programmer cable to the usb port on the back of the computer. Most computers have two usb ports. Either port will work. The computer does not need to be turned off when conne...
2 installation to install the mapsource software upgrade including usb data card programmer support : 1. Insert the programmer cd-rom into your computer’s cd-rom drive. 2. Click the start button and select “run...” 3. Then type in the drive letter of your cd-rom drive followed by the mapsource updat...
3 installation installing a data card in the programmer to install a garmin data card: 1. Insert the data card (label up and pin connector end first) into the card slot in the programmer (picture to the right). 2. Be certain to install the data card completely into the slot to be certain pin connect...
4 trouble shooting trouble shooting guide symptom probable cause remedy windows does not recognize that the programmer has been connected to the computer. When preparing to transfer data, a “no compatible device available.” message appears. When preparing to transfer data, a “there is no data card i...
Help us to better support you by completing our on-line registration today! Have the serial number of your usb data card programmer handy and connect to our website ( www.Garmin.Com ). Look for the product registration link on the home page. Why should you register your usb data card programmer? • n...
©2000 garmin corporation garmin international 1200 east 151st street, olathe, kansas 66062, u.S.A garmin (europe) ltd. Unit 5, the quadrangle, abbey park industrial estate, romsey, so51 9aq, u.K. Garmin (asia) corporation no 68, jangshu 2 nd road, shijr, taipei county, taiwan www.Garmin.Com part num...
