1. DL manuals
  2. Garmin
  3. Marine Radio
  4. VHF 725e
  5. Owner's Manual

Garmin VHF 725e Owner's Manual

Other manuals for VHF 725e: Specifications
Manual is about: submersible marine radio

Summary of VHF 725e

  • Page 1

    Owner’s manual and reference guide vhf 725e submersible marine radio.

  • Page 2

    © 1999 garmin corporation garmin international, inc. 1200 e 151 st street, olathe, kansas 66062 u.S.A. Tel. 913-397-8200 or 800-800-1020 fax. 913-397-8282 garmin (europe) ltd. Unit 5, the quadrangle, abbey park industrial estate, romsey, so51 9aq u.K. Tel. 011-44-1794-519944 fax. 011-44-1794-519222 ...

  • Page 3

    I introduction about this manual thank you for choosing the garmin vhf 725e. To get the most from your new vhf marine radio, take time to read through this owner’s manual in order to understand all of the operating features. This manual is organized into three sections for your convenience: the intr...

  • Page 4

    Ii introduction compliance statements ce compliance statement this device complies with the essential requirements of ce for meeting standards en301-178 and en 300-828. Warning! This transmitter will operate on frequencies (channels) that have restricted use. Use of international, u.S., and canadian...

  • Page 5

    Iii introduction warnings and precautions radio licenses the vhf 725e user accepts all responsibility for obtaining the proper licensing before using the transmitter. In many instances, you must have a current radio station license before using this transceiver. It my be unlawful to operate a ship s...

  • Page 6

    Iv introduction warnings and precautions important! Read all instructions carefully and completely before using the vhf 725e marine radio. This device is intended only as an aid to boating safety and navigation. The performance of the vhf 725e can be affected by many factors including environ- menta...

  • Page 7

    1 getting started table of contents section one introduction packing list....................................................................I regulatory agency compliance statement........................Ii cautions.....................................................................Iii-iv section ...

  • Page 8

    2 getting started unit description flexible antenna lcd display screen scan key memory key channel band selection key +/- volume control keys up/down arrow channel selection keys microphone speaker squelch key press to talk (ptt) key hi/low power-lock key tri-watch - channel 16 key power/backlightin...

  • Page 9

    3 getting started unit description the vhf 725e is a 5 watt marine vhf communications transceiver in a convenient handheld package. A keypad located on the front of the unit provides one- hand control of communication features. The knobless design allows push-button squelch and volume adjust- ment. ...

  • Page 10

    4 getting started keys & function displays eleven keys provide access to all of the unit’s features and functions. When any key (except the ptt key) is pressed, the unit will acknowledge by emitting a single beep confir- mation tone. Some keys have dual functions and those keys on the front of the u...

  • Page 11

    5 getting started keys & function displays memory key memory key - pressing this key after selecting a channel places that channel into the scanning memory. Pressing this key when a channel is stored in memory (as indicated by the mem icon on the display) will remove the channel from memory. A maxim...

  • Page 12

    6 getting started keys & function displays squelch key - this key breaks the squelch (unmutes the audio) when pressed and held. It is also sed to set the squelch threshold (the level at which only strong signals can be received). The squelch threshold is set by pressing and holding the squelch key w...

  • Page 13

    7 getting started keys & function displays the vhf 725e lcd display screen gives indication of channels being monitored, battery power level, volume level, and the status of all unit features. Channel number indicator - this large numeral display indicates the selected operating channel or the squel...

  • Page 14

    8 getting started lock indicator - this indicator is displayed when the lock feature is active. Battery level indicator - this battery shaped icon displays information about battery capacity in 25% increments. This indicator is always active. Squelch indicator - this display appears whenever the sq,...

  • Page 15

    9 getting started hi/low power indicators - these displays indicate the transmitter power level. Note: some channels only permit transmission on low while others allow only receive operation. Scan indicator - this display provides indica- tion that the scan feature is active. Receive (rx) indicator ...

  • Page 16

    10 getting started important information for first time users about operating a marine radio if you are a first time user of a marine radio, you should be aware of methods for operating your garmin vhf 725e. International vhf radio communication is governed by the international telecommunications un...

  • Page 17

    11 getting started maritime radio services operation the four groups you will have occasion to use are the u.S.A. Regular band of 52 channels, the canadian band of 56 channels, the international band of 55 channels, and 15 programmed-in marina channels and 57 programmed-in private channels on the in...

  • Page 18

    12 getting started here is a grouping of the channels and a brief description of their use. Channels 5,12, 14, 20, 65, 66, 73, 74,77: port operations - can be used by any vessel for communications between ships and ship- to-coast stations for messages relating to operational handling, movement and s...

  • Page 19

    13 getting started maritime radio services operation channel 13: navigation - used by any vessel for safety communica- tions regarding the maneuvering of vessels or directing of a vessels movements. Ship-to-ship and secondarily ship-to-coast communica- tions. Commonly called the bridge-to-bridge cha...

  • Page 20

    14 getting started maritime radio services operation private channels: these are channels that require special registration to use and must be programmed into the international channel band by your radio dealer. Contact your radio dealer to determine availability of programming and private channels....

  • Page 21

    15 getting started antenna & battery installation installing the antenna the antenna is an essential part of your vhf 725e and the unit should never be operated without the antenna installed, as this may result in damage to the unit. The antenna receives signals best when held upright and is less ef...

  • Page 22

    16 getting started 4. If you have an additional nicad battery pack to use as a spare, you may insert it directly into the charging stand for recharging. 5. To remove a depleted battery pack and install a spare, lift up on the d-ring on the base of the battery pack and use it or a coin inserted in th...

  • Page 23

    17 getting started setting the squelch threshold note: you will notice an “a” indicator adjacent to some channel numbers in the usa and canadian bands. These are simplex channels (transmitting and receiving on the same frequency) while the international counterpart is a duplex channel (transmitting ...

  • Page 24

    18 getting started adjusting the volume the volume key may be adjusted using the +/- keys. The volume level is indicated by the band of gradually rising bars on the lcd display. To adjust the volume: 1. Press the + key to increase the volume or the - key to decrease the volume. (figure 6) scanning c...

  • Page 25

    19 getting started tri-watch note: if the ptt key is pressed during scanning (when the display is changing) it will cancel scan and stop at the channel last scanned. If a channel is static (being received) you must transmit within 5 seconds after the received broadcast ends before scan moves to the ...

  • Page 26

    20 getting started programming call channels note: if you enter channel 16 into memory for the scan mode, it will not have the priority it receives in the tri-watch mode. Programming call channels the call channel is simply a channel that has been selected from the list of channels for each band (us...

  • Page 27

    21 getting started receiving and transmitting receiving and transmitting whenever the vhf 725e is powered-up (on) it is in the receiving mode. If the unit is monitoring a channel that is broadcasting, you will hear that transmission. It is possible to monitor any channel on any band, but transmis- s...

  • Page 28

    22 getting started 6. Press the scan key to monitor the selected channels. (figure 10) 7. Press the 16 key once if you want to monitor the emergency channel (16). (figure 11) 8. Press the call key if you want to monitor the programmed call channel. 9. Press and hold the 16 key if you want to activat...

  • Page 29

    23 getting started transmit display press and hold while transmitting 4. Press and hold the ptt (press to talk) key and begin your transmission. The tx symbol will appear on the lcd display. (figure 12) 5. Speak directly into the microphone on the front of the unit (see page 2) and hold the unit ver...

  • Page 30

    24 getting started backlighting & key lock features backlighting the lcd display and keypad the backlighting feature is used to improve readability of the lcd display and keypad in dim light. 1. Press and release the pwr key after the unit has powered on. The display and keypad will be illuminated f...

  • Page 31

    25 accessories & installation appendix a standard accessories & replacement components (included with the vhf 725e) antenna......................................... Part number: 700-00010-00 nicad battery pack kit (includes battery pack and charger & charging stand .) ..................................

  • Page 32

    26 optional accessories appendix a optional accessories nickel metal hydride rechargeable battery pack, (50% more capacity than the nicad pack) ..........................................Part number: 010-10245-00 spare nicad battery pack...................... Part number: 010-10189-00 vhf 725e soft c...

  • Page 33

    27 specifications appendix b physical: size: 5.5”h x 2.0”w x 1.3”d (14.0 x 5.0 x3.3cm) weight: approximately 12.1 oz (.35kg) temperature range: -4 to +158 degrees f (-20 to + 70 degrees c) transceiver: frequency bands: all u.S., canadian, and international marine channels channel spacing: 25khz rece...

  • Page 34

    28 channel number frequency (mhz) type of traffic function usa can int tx rx ship to ship ship to shore 01 01 156.050 160.650 com’l, port ops, vts yes yes 01a 156.050 156.050 com’l, port ops, vts yes yes 02 02 156.100 160.700 port ops yes yes 03 03 156.150 160.750 com’l, port ops, vts yes yes 03a 15...

  • Page 35

    29 vhf channel list appendix c channel number frequency (mhz) type of traffic function usa can int tx rx ship to ship ship to shore 65 156.275 160.875 port ops. No yes 65a 65a 156.275 156.325 port ops. No yes 66 156.325 160.925 port ops. Yes yes 66a 156.325 156.325 port ops. 1 watt only yes 66a 156....

  • Page 36

    30 maintenance & troubleshooting storage: store the vhf 725e in a cool, dry location when not used for prolonged periods. When stored for more than six months, remove alkaline batteries to prevent leakage from expended cells. While the garmin vhf 725e is designed to withstand immersion in water (wit...

  • Page 37

    31 appendix d if using the optional nicad* battery pack: fully charge the battery pack before its first use. The battery pack requires 12 hours for a full charge and should not be charged in excess of this time period.. Charge only with the vhf 725e charging unit provided with the nicad battery pack...

  • Page 38

    32 maintenance & troubleshooting troubleshooting guide symptom probable cause remedy unit does not come on batteries are exhausted. Replace batteries no sound from speaker squelch threshold level too set to a lower high. Threshold point. No channel broadcast is move to another being received channel...

  • Page 39

    33 appendix e messages messages the vhf 725e responds to operating conditions in two ways, lcd display screen messages and audio tones. These messages provide notification of errors in operation or the status of vhf 725e features. Audio messages confirmation tones - these tones, consisting of a sing...

  • Page 40

    34 glossary glossary of radio terminology and abbreviations canadian channels: channel designations as defined and regulated by industry canada, (ric), marine communications & traffic services. Duplex: transmit and receive on different frequencies. Fm: frequency modulation international channels: ch...

  • Page 41

    35 appendix g a accessories............................25 antenna installation..............15 b backlighting..........................24 battery pack installation............15 belt clip................................25 c call channel programming.......20 calling channel....................13 caut...

  • Page 42

    36 limited warranty garmin corporation warrants this product to be free from defects in materials and manufacture for three years from the date of purchase. Garmin will, at its sole option, repair or replace any components that fail in normal use. Such repairs or replacement will be made at no charg...

  • Page 44

    © 1999 garmin corporation garmin international, inc. 1200 e 151 st street, olathe, ks 66062 u.S.A. Garmin (europe) ltd., unit 5, the quadrangle, abbey park industrial estate, romsey, so51, 9aq u.K. Garmin (asia) corp., 3rd floor, no. 1, lane 45, pao hsing road, hsin tien, taipei, taiwan r.O.C. Www.G...