Golden Designs GDI6228 Owner's Manual - page 12
D. Installing the REAR PANEL
1. Place the REAR PANEL onto the recessed area on the FLOOR PANEL. Attach the REAR
PANEL to the SIDE PANELS and buckle together.
E. Installing the BENCH EMITTER PANEL and BENCH
1. Slide down the BENCH EMITTER PANEL by lining up its sides with the vertical guides on
each side panel. The emitter grid will face outward (toward the front of the sauna). Push the
BENCH EMITTER PANEL all the way down until it is touching the FLOOR PANEL and is
secured in place.
2. Plug in the BENCH EMITTER connector to the corresponding inlet located on the REAR
PANEL. Also, plug the FLOOR EMITTER connector to the corresponding inlet on the REAR
PANEL.
3. Install the BENCH by sliding it over the horizontal bench guides on the side panels. Push the
BENCH all the way in until it touches the REAR PANEL and is secured in place. Make sure to
install the BENCH with the smooth and finished side facing up.
F.
Installing the ROOF PANEL
1. The side with the power supply faces up.
2. The edge nearest the power supply is the front of the ROOF PANEL. Be careful of the wires
coming from the REAR PANEL when you set the ROOF PANEL down onto the panels. Feed
the wires through the holes in the ROOF PANEL. Do the same for any wiring harnesses
coming from the SIDE or FRONT PANELS.
3. Be careful not to force the ROOF PANEL into place. Make sure that the wires are properly fed
through the holes. (see figure 9)
4. When all the wires are fed through their appropriate holes, lower the ROOF PANEL into place.
5. The four screws taped to the four sides of the ROOF PANEL are used to mount the ROOF
PANEL to each of the wall panels. Use the predrilled holes on the four sides of the ROOF
PANEL.
10