GOLDEN STATE INSTRUMENT CO GS-2800 CC Instruction Manual
HOW TO USE CAMERA
：
1) Connect a 75 ohm coaxial cable from the camera rear panel
BNC connector(video out) to a monitor.
2) Use only AC/DC power supply. Be sure to connect each lead to
appropriate terminal.
3) Once the image appears, adjust the focus of lens on an object
while looking at the monitor.
4) Screw the lens figer tightly into the C mount. If CS mount is
required, release 2 screws attaching the mounting base, also,
release one screw from the bottom of the camera,and one screw
from cover of camera.
INSTALLATION INSTRUCTION
5) If the lens has Video Drive Auto Iris, connect three wires to the
Read these instructions carefully before
4 pin plug as shown in figure below.
trying to put the device into operation.
6) If the lens has DC Drive Auto Iris, connect four wires to the 4
pin plug as shown in figure below.
INTRODUCTION
The 1/3 inch color camera has a
Auto IRIS Pin Definitions
CCD image sensor and all solid state circuit
VIDEO
DC
which provide extremely long life and high
DRIVER
DRIVER
reliability with low lag and high burn resi-
1
+12V
DAMP-
stance, and is not subject to distortion from
2
VIDEO
DAMP+
magnetic, and the camera functions reliably
3
NC
DRIVE+
in a wide temperature range.
4
GND
DRIVE-
MAIN FEATURES
7) Slide the switch on the back panel to the position of
1) By applying high sensitivity, a minimum
“ON ”.If electronic shutter function is required.
object illuminance of 0.8LUX(at F/1.2)
8) Slide the switch on the back panel to the position of
becomes possible.
“OFF ”while the Auto Iris lens is being used.
2) Longevity and no image distortion.
9) Slide the switch on the side to the position of “VIDEO”
3) The camera can use a C mount or an optional
in using the Video Drive Auto Iris lens. The switch should
CS mount lens ,therefore,general use of a variety be slided to the position of “DC ” for DC Drive Auto
of C mount or CS mount lenses is possible.
Iris lens. For better performance in using the DC drive
4) CCD iris with electrical shutter,Max
lens,the user may adjust the level adjustment (level) to
1/120,000 Sec.
the right position.
5) DC12V INTERNAL SYNC.
10) Back Light Compensation is ON/OFF switch control.
AC24V AUTOMATIC LINE LOCK.
A. FUNDAMENTAL SYSTEM
1
2
3
4
1/3" COLOR SONY CCD CAMERA
VIDEO MONITOR
VIDEO OUT
GS-2800 CC
GOLDEN STATE INSTRUMENT CO.
1/3" COLOR CCD CAMERA
1/3" COLOR SONY CCD CAMERA
GS-2800CC
INSTRUCTION MANUAL
1/3" COLOR CCD CAMERA
GS-2800CC