Golden Technologies PR-501L26 Owner's Manual - page 4
L.E.D. light
L.E.D. light
From motor
To outlet
115-120V A.C.
DC Power
Bottom view of
Transformer
Transformer
Plug
Install two 9 volt batteries
in transformer for battery
backup (See page 7)
(batteries not included)
3. Place the chair in the desired
position in the room, keeping it 17"
away from the wall. If placing the
chair into a corner, keep it 17" from
the wall as shown. See distance
chart below for your model.
W
all
Side
View
Corner
Top
View
17"
17"
17"
Distance Required From Wall When Reclined
Model Number
Wall
Corner
Model Number
Wall
Corner
4. Adjust the leg levelers on the bottom of the chair if necessary to level the chair.
Some high pile carpets can obstruct the footrest operation by rubbing against
it. Adjust the levelers to a height above the pile.
5. Slide the hand control from between the back and arm out toward the back of
the chair. Secure the cord into the quick release cable clamp located above the
magazine pocket on the arm of the chair.
4
Installation Of Your Golden Power Lift Chair
Models: PR-200, PR-355M, PR-355L, PR-359M, PR-359L, PR-401,
PR-410, PR-501JP, PR-501S, PR-501S-23, PR-501M, PR-501L, PR-501T,
PR-643, PR-747, PR-751TY, PR-752, PR-906
1. Remove the transformer from the transformer box (located behind the lower
outside back).
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect the power
cable from the chair into the transformer as shown. Power cable is located under
the chair attached to the motor with white zip tie. Remove zip tie, extend the
cable under and out behind the chair.
PR-200
11 in.
11 in.
PR-355M
17 in.
17 in.
PR-355L
18 in.
18 in.
PR-359M
17 in.
17 in.
PR-359L
18 in.
18 in.
PR-401
17 in.
17 in.
PR-410
19 in.
19 in.
PR-501JP
17 in.
17 in.
PR-501S
17 in.
17 in.
PR-501S-23
17 in.
17 in.
PR-501M
17 in.
17 in.
PR-501L
18 in.
18 in.
PR-501T
19 in.
19 in.
PR-501M-26D
17 in.
17 in.
PR-501L-26D
18 in.
18 in.
PR-501T-28D
19 in.
19 in.
PR-643
18 in.
18 in.
PR-747
18 in.
18 in.
PR-751
18 in.
18 in.
PR-752
19 in.
19 in.
PR-906
6 in.
6 in.
PA
TENTED