Above-ground pool automation by 888-921-pool www.Goldlinecontrols.Com questions? Refer to www.Goldlinecontrols.Com for latest manual revisions, additional information and helpful service. Or, you may visit your local authorized aqua trol ® dealer or call 888- 921-pool (7665) for assistance. Electrol...
Important safety instructions when using this electrical equipment, basic safety pre- cautions should always be followed, including the follow- ing: • read and follow all instructions • disconnect all ac power during installation. • warning - to reduce the risk of injury, do not permit children to u...
Table of contents operation operation operation operation operation the aqua trol the aqua trol the aqua trol the aqua trol the aqua trol ® ® ® ® ® ..... ..... ..... ..... .......................................................................1 water chemistry.... Water chemistry.... Water chemistry...
1 operation the aqua trol ® is an automatic chlorine generation system with a built-in filter pump timer designed specifically for above ground pools. The operation re- quires a low concentration of salt (sodium chloride) in the pool water at levels low enough that it normally will not be tasted. Th...
National spa and pool institute (nspi). The only special requirement for the aqua trol is the salt level and stabilizer. It is important to maintain these levels in order to prevent corrosion or scaling and to ensure maximum enjoyment of the pool. Test your water periodically. Your local pool store ...
3 salt level use the chart on page 4 to determine how much salt in pounds (or kgs) needs to be added to reach the recommended levels. Use the equations below (measure- ments are in feet/gallons and meters/liters) if pool size is unknown. The ideal salt level is between 2700-3400 ppm (parts per milli...
4 gallons and (liters) of pool/spa water 12,000 14,000 16,000 18,000 current salt level (45000) (52,500) (60,000) (67,500) ppm 0 320 (145) 373 (170) 427 (194) 480 (218) 200 300 (136) 350 (159) 400 (182) 450 (205) 400 280 (127) 327 (148) 373 (170) 420 (191) 600 260 (118) 303 (138) 347 (158) 390 (177)...
Stabilizer (cyanuric acid ) always check stabilizer (cyanuric acid), when checking salt. These levels will most likely decline together. Use the chart below to determine how much stabi- lizer must be added to raise the level to 80 ppm. 5 plumbing the cell and flow switch (not used on -rj systems) ar...
6 controls timer the pool filter pump should run long enough to circulate the entire volume of pool water each day. This will vary depending on pump size, pool plumbing and pool size. Consult a local pool store to help determine the appropriate run time for your pool. Set the aqua trol's timer by ro...
7 8 no flow when illuminated, the flow switch has detected no flow and the aqua trol ® has stopped generating chlorine. A flashing led indicates a 15/ 60 second time delay period. Test salt level when flashing, the salt level is low (below 2700ppm) and aqua trol is generating at low efficiency. When...
7 8 no flow when illuminated, the flow switch has detected no flow and the aqua trol ® has stopped generating chlorine. A flashing led indicates a 15/ 60 second time delay period. Test salt level when flashing, the salt level is low (below 2700ppm) and aqua trol is generating at low efficiency. When...
6 controls timer the pool filter pump should run long enough to circulate the entire volume of pool water each day. This will vary depending on pump size, pool plumbing and pool size. Consult a local pool store to help determine the appropriate run time for your pool. Set the aqua trol's timer by ro...
Stabilizer (cyanuric acid ) always check stabilizer (cyanuric acid), when checking salt. These levels will most likely decline together. Use the chart below to determine how much stabi- lizer must be added to raise the level to 80 ppm. 5 plumbing the cell and flow switch (not used on -rj systems) ar...
4 gallons and (liters) of pool/spa water 12,000 14,000 16,000 18,000 current salt level (45000) (52,500) (60,000) (67,500) ppm 0 320 (145) 373 (170) 427 (194) 480 (218) 200 300 (136) 350 (159) 400 (182) 450 (205) 400 280 (127) 327 (148) 373 (170) 420 (191) 600 260 (118) 303 (138) 347 (158) 390 (177)...
3 salt level use the chart on page 4 to determine how much salt in pounds (or kgs) needs to be added to reach the recommended levels. Use the equations below (measure- ments are in feet/gallons and meters/liters) if pool size is unknown. The ideal salt level is between 2700-3400 ppm (parts per milli...
National spa and pool institute (nspi). The only special requirement for the aqua trol is the salt level and stabilizer. It is important to maintain these levels in order to prevent corrosion or scaling and to ensure maximum enjoyment of the pool. Test your water periodically. Your local pool store ...
1 operation the aqua trol ® is an automatic chlorine generation system with a built-in filter pump timer designed specifically for above ground pools. The operation re- quires a low concentration of salt (sodium chloride) in the pool water at levels low enough that it normally will not be tasted. Th...
Table of contents operation operation operation operation operation the aqua trol the aqua trol the aqua trol the aqua trol the aqua trol ® ® ® ® ® ..... ..... ..... ..... .......................................................................1 water chemistry.... Water chemistry.... Water chemistry...
Important safety instructions when using this electrical equipment, basic safety pre- cautions should always be followed, including the follow- ing: • read and follow all instructions • disconnect all ac power during installation. • warning - to reduce the risk of injury, do not permit children to u...
Above-ground pool automation by 888-921-pool www.Goldlinecontrols.Com questions? Refer to www.Goldlinecontrols.Com for latest manual revisions, additional information and helpful service. Or, you may visit your local authorized aqua trol ® dealer or call 888- 921-pool (7665) for assistance. Electrol...
