G g l l - - 2 2 3 3 5 5 solar pool heating control m automatically maximizes solar system heat collection m precise calibrated temperature setting dial m single model handles all systems-old or new pools, spas, 12 or 24vac actuators. M automatic switch over from solar heating to nocturnal cooling if...
G g l l - - 2 2 3 3 5 5 solar pool heating control corporate office: 42 ladd street east greenwich, ri 02818 (401) 884-6990 (401) 884-1500 fax western regional office: 7171 alvarado road, suite 104 la mesa, ca 91942 (619) 462-4298 (619) 462-4498 fax model gl-235-lv-hv the model gl-235-lv-hv has two ...
Gl-235 solar pool controller installation & operation manual for models gl-235-lv gl-235-lv-hv www.Goldlinecontrols.Com 888-921-7665 north kingstown, ri usa ldline controls inc. G.
Installation mounting the gl-235 is designed for outdoor use. Mount the box vertically with the knockouts facing downward. For safety, the gl-235 must be a minimum of 5 feet (horizontally) from the pool or spa. Power input turn off power at circuit breaker before wiring. Remove the internal panel to...
All controls are shipped with the output voltage set to the industry standard 24vac. To use the gl- 235 with older 12vac valves, move jumper j4, located on the right side of the circuit board. The gl-235 provides two different types of connections to the pool/spa actuators. For older actuators with ...
Freeze protection if you are relying on the collectors naturally draining to provide freeze protection, it is very important that you use a non-positive seal valve or drill a hole (1/8"--1/4") in the diverter of a positive seal valve to allow the collectors to drain. Alternatively, the gl-235 contro...
Operation for normal operation place the switch in the “auto” position and adjust the desired pool/spa temperature setting. The “power” led indicator should always be on. (note: during initial power up, the “power indicator will blink for approximately 10 seconds while it stabilizes temperature read...
“check sensor” indicator on if the “check sensor indicator is on and not blinking, there may be a possible open circuit or short circuit with the pool sensor. Using a voltmeter, measure the dc voltage across the terminals of the pool sensor as indicated in figure 5. If the voltage is close to zero v...
Basic installation of gl-235-lv figure 2 7.
Gl-235-lv-hv with high voltage output used for timer override figure 3 8.
Gl-235-lv-hv with high voltage output used for booster pump figure 4 9.
1 0 measuring voltage of pool sensor (use the same method to measure the solar sensor) figure 5.
Technical assistance for help in installing, operating, or troubleshooting this control, you may call for technical assistance at 800-921-7665. Goldline controls technicians are available from 8:00am to 8:00pm eastern time, monday through friday. You may call at other times and leave a message, and ...
Www.Goldlinecontrols.Com 888-921-7665 092007c limited warranty - solar controls limited warranty - solar controls limited warranty - solar controls limited warranty - solar controls limited warranty - solar controls this warranty statement is applicable to all solar control products manufactured by ...