1. DL manuals
  2. Goldline
  3. Water System
  4. GOLDLINE-50
  5. Installation & Service Manual

Goldline GOLDLINE-50 Installation & Service Manual

Other manuals for GOLDLINE-50: Installation & Service Manual
Manual is about: Reverse Osmosis System

Summary of GOLDLINE-50

  • Page 1

    System tested and certified by nsf in - ternational against nsf/ansi standard 58 for the reduction of the claims speci- fied on the performance data sheet (page 3) (1) good water warehouse inc. 1700 e walnut ave fullerton ca 92831 (714) 441-2893 (714) 441-0525 fax system conforms to nsf/ansi standar...

  • Page 2: Goldline Manual Introduction

    (2) (3) goldline manual introduction the goldline reverse osmosis drinking water system is designed for easy installation and maintenance. You will insure a successful installation as well as reliable operation by carefully reading this manual and following the operational guidelines. Please note th...

  • Page 3: Good Water Warehouse Inc.

    (2) (3) systems tested and certified to nsf/ansi 58 good water warehouse reverse osmosis system nsf 58 part number: goldline-50 gww inc. 1700 e walnut ave fullerton ca 92831 (714) 441-2893 (714) 441-0525 fax good water warehouse inc. 1. Do not use with water that is microbiologically unsafe or of un...

  • Page 4: Starting Your Installation

    (4) (5) preparation check the following list of components to ensure that all parts are packed with your system. Compression fittings are used on the supply feed and drain connector. To insure a optimal seal, tubing should be cut with the end square. An angled cut or distortion of the tubing will no...

  • Page 5: Installation

    (4) (5) installation supply feed installation (a) flex line: loosen nut and separate cold water riser tube from faucet shank. Gently bend riser tube so that slip joint fits onto faucet shank. Replace the existing cone washer with new washer provided in installation kit onto cold water riser tube. Re...

  • Page 6

    (6) (7) drilling the faucet hole the product water faucet may be installed on any flat surface at least 2” in diameter. Check the underside of the location for interference. Porcelain/enamel sinks a 1” variable speed drill is recommended for this procedure. A spring loaded relton style drill set is ...

  • Page 7

    (6) (7) installation - product water faucet do not use the first two reservoirs of water allow the reservoir to fill for 12 hours. Dispense this water to drain. This process removes the factory installed sanitizing solution from the entire system and sends it to the drain. Repeat this process one mo...

  • Page 8

    (8) (9) orange white orange black white 24 25 14 1/4" white 10 1. Supply feed 3095-8 2. 1/4" male connector ci010822w 3. Filter housing 1h4whwh 4. Filter housing 'o-ring 143026 5. 5 micron filter 1227867-v 6. Carbon block 32-250-125-975 7. Carbon block 32-250-125-975 8. 1/4" nipple n-14 9. 1/4" male...

  • Page 9

    (8) (9) activation, care, & troubleshooting activating the system for the first time make sure all water supply/drain lines are secure and free from leakage. Slowly turn the saddle valve counterclockwise until fully open. Check stem seal for leakage. If necessary tighten stem nut lightly. Turn stora...

  • Page 10

    (10) printed in usa goldline manual 10/2007 the goldline reverse osmosis system is warranted to be free from defects in materials and workmanship under normal use within the operating parameters listed below. For a period of three years from the date of purchase good water warehouse will repair or r...