Goldmaster GVC-7506 Manual - Important!
8
CLEANING AND REPLACEMENT THE FILTERS
Cleaning the HEPA filter
The HEPA filter and the HEPA cover should be cleaned regularly. Cleaning
is best done when emptying the dust container. To do this follow the
instructions in the Emptying dust container section.
1.Switch off the vacuum cleaner and disconnect the plug from the mains.
To do this always pull on the plug and not on the cable.
2.You can pull the dust container together with the
cleaning system out of their anchoring with the aid
of the carrier handle on the dust container. Take
hold of the carrier handle on the dust container
and pull it upwards. Now pull the dust container out
and loosen the HEPA cover and HEPA filter out of
the dust container with the aid of the lateral
unlocking button.
3.Turn the dust container cover carefully until it is
released and the HEPA filter will come away easily
4.Now rinse the HEPA filter under running water and allow it to dry.
5.Place the HEPA filter back in the HEPA cover (or replace with a new one) and
fit it into the dust container. Then fit the dust container back into position in the
cyclone dust container until it snaps into place. Your cyclone vacuum cleaner
is now ready for use again.
Cleaning or Replacing the Motor Protection Filter
Always unplug the appliance before you replace the filter.Lift out the dust
container from the vacuum cleaner.
Your vacuum cleaner is equipped with the per motor protection filter.Replace
the filter once 100 hours.
1. Lift the dust container from the vacuum cleaner.
2. Pull out the filter holder out of the appliance.
3.Rinse the filter under cold running water and allow dry.
We recommend you to replace the filter regularly.
IMPORTANT!
Never operate the vacuum cleaner without the dust bag or filter.