Goldmund SR8 User Manual - page 9
7
User’s manual - GOLDMUND SR8 UNIVERSAL PREAMPLIFIER
R E M O T E - C O N T R O L
Your SR8 has built-in remote-control for volume, balance and input selection.
The Mute circuit can also be activated by the remote. To mute or de-mute the SR8 with the
remote, press the "Mute/Stby" key briefly.
To put the SR8 in Standby mode, press the "Mute/Stby" key continuously until the SR8 goes
to Standby, indicated by the Standby Led on the front panel.
The SCREEN and LIGHT keys will be used in future applications.
The MUTE/STDBY key is used to control the muting and standby of the unit (see before).
The VOL+ and VOL- keys are adjusting the general volume.
The 4 balance keys (diamond configuration) are controlling
the Left/Right and Front/Rear balance directly, maintaining a constant global volume.
The 1 to 7 keys are selecting the source to listen.
MODE KEY
Selection of a mode for adjustment of the format of the incoming signal.
CALIB KEY
Lights the Leds selecting the remote red-inscribed functions, to adjust the level of Center and
Subwoofer channels when in multi-channel operation. To deactivate, press the CALIB key
again.
TEST KEY
Activates the pink noise.
In the Test mode:
• Use the balance right and left keys of the "diamond" to select one channel at a time.
• The balance front and rear keys are used for adjusting the selected speaker level.
• The In4 key makes all speakers play the pink noise together.
• The In1 key returns the pink noise only to the selected speaker.
• The In3 key stops the pink noise from all speakers.
• The In2 key is a toggle switch for the pink noise on the selected speaker.
The SR8 can be controlled by any RC5 coded remote-control emitter. The codes are availa-
ble upon request. Most of the programmable transmitter units available have the capabili-
ties to drive the SR8 as a standard digital preamplifier, for all the specified functions.